Quoizel CPB8408SPB Installation Manual

Please go to www.quoizel.com
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Light Source: (1) A19 Medium Base Bulb 100W Maximum, Medium Base Vintage Bulb is recommended, bulb not included.
Estimated Assembly Time:
Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact your original place of purchase.
Fixture can only be mounted in the direction indicated on page 2.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Package Contents
Inner
A Backplate
x 1
Glass Panel
D
x 6
-
STEP 1 Install Glass Panels
A. Insert the top edge of the Glass
Panel (D) into the slot in the
Fixture Body (C) and fold tabs in
the bottom edge of the Fixture
Body (C) onto the bottom edge
of the Glass Panel (D) to secure
the Glass Panel (D).
Figure 1
2019 QuoizelInc.
for product cleaning tips. Go to the
20-30 minutes
Mounting screw
B
x 4
Fixture Body
C
x 1
visit us on-line at www.quoizel.com
Installation Guide #IS-CPB8408SPB
For Style CPB8408SPB
Care + Maintenance selection.
STEP 2 - Install the Inner Backplate to the outlet box
A. Place the supply wires and ground wire through the Inner
Backplate (A). Attach the Inner Backplate (A) to the outlet box with
the head of the green ground screw facing you. Secure it with
outlet box screws (not included). Tighten until snug with
screwdrivers.
Outlet Box
STEP 3 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
C
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Slot
from outlet box
Tab
Black wire from
outlet box (or Red)
Bare, or Green
Ground wire
from outlet box
D
1of2
Green Ground Screw
A
Figure 2
White wire
Green Ground Screw
on the Crossbar
Outlet Box Screw
(not included)
Supply Wires
with Ground Wire
White wire
from fixture
Black wire
from fixture
Ground wire
from Fixture
Figure 3
ReleasedDate:2019-03-19