Ryobi AC14RL3A Quick Start Manual

DC tRImmeR
RePlACemeNt sPool
AC14Rl3A
WARNING:
To reduce the risk of injury, user must read and understand the opera-
tor's manual for their tool. Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do so could result in ob-
jects being thrown into your eyes, resulting in possible serious injury.
CAlIfoRNIA PRoPosItIoN 65
WARNING:
May contain chemicals known to California to cause cancer, birth defects or other reproductive harm.
 Remove the battery pack.
 Push in tabs on side of spool retainer.
 Pull spool retainer up to remove.
 Remove the old spool.
 To install the new spool, make sure the string is captured in the slot on the new spool.
Make sure the end of the string is extended approximately 6 in. beyond the slot.
 Install the new spool so that the string and slot align with the eyelet in the string
head. Thread the string into the eyelet.
 Pull the string extending from the string head so the string releases from the
slot in the spool.
 Reinstall the spool retainer by depressing tabs into slots and pushing down
until spool retainer clicks into place.
987000-877
4-4-11 (Rev:02)