SHURflo Aviani 133-0702-CP Installation Instructions

I
NSTALLATION
Your new SHURflo Marine Grade Faucet will
give you years of trouble-free performance.
Thank you for choosing SHURflo Marine
Grade Faucets. Please read these instructions
carefully before installing your new faucet. If
you have any additional questions about the
installation of this faucet, please feel free to
contact one of our friendly customer service
representatives at 1-800-854-3218.
1
2
3
4
5
I
NSTRUCTIONS
(1) Turn off the water supply to your existing faucet (this procedure will vary depending on the
specific plumbing system installed on your boat). Cover the sink drain to prevent any small
parts or debris from falling in. Remove your existing faucet, taking care not to damage your
existing water lines. Clean sink area in preparation for new faucet.
(2) Screw both mounting bolts into the bottom of the faucet. One end of the bolt is slotted to
allow the use of a screwdriver to secure. Screw both connector hoses into the bottom of
faucet (note: it is NOT necessary to use Teflon (Plumber's) tape on this connection as the
o-rings will prevent leaks). Use a wrench or pliers on the hex nut molded into the brass
shaft portion of the hoses. Do NOT attempt to tighten by turning the hose itself.
(3) Place your new faucet through the hole in your sink. Align the base ring with the bottom of
the faucet and make sure the base gasket properly lines up with the bottom of the base.
From under the sink, slide the rubber horseshoe washer then the metal horseshoe washer
onto the mounting bolts. Adjust faucet position on the sink as desired. Thread the lock
nuts onto the mounting bolts and tighten. It may be necessary to re-adjust the faucet
position by slightly loosening the lock nuts, adjusting to the desired location, then re-
tightening the lock nuts.
(4) Connect water supply lines (not provided) to the connector hoses. Wrap the brass fittings
on the connector hoses with Teflon (Plumber's) tape. Follow the appropriate steps
depending on your water supply lines. If you have pre-assembled water supply hoses with
threaded connectors, simply screw on supply hose. If you have plastic water lines with
formed ends, water lines will seat partially up into the brass fittings. Connect by tightening
the coupling nuts. We do NOT suggest using sweat fittings as they are prone to blow-outs.
(5) After installation is complete, remove the aerator. Be careful not to scratch the finish. Turn
the water supply back on and allow both hot and cold water to run for at least one full
minute. While water is running, check all connections for leaks. Replace aerator.
Connections may need re-tightening.
133-0702-CP
Aviani
High Arch
Galley / Wet Bar Faucet
Chrome