Advertisement
Quick Links
I
NSTALLATION
OEM Version
Attention Manufacturers:
Please include this Installation
Instruction sheet with your Owner's
Documentation.
1
(1) Turn off the water supply to your existing faucet (this procedure will vary depending on the
(2) Remove handle and wall plate from valve assembly. Remove the blue/red cap and loosen the set
2
(3) From the back side of the bulkhead, slide the valve assembly through the hole in the bulkhead.
3
(4) Connect hot/cold water supply lines (not provided) to the inlet tubes. The inlet tubes are the 1/2"
4
(5) Connect 1/2" NPT water line from the shower head or bulkhead elbow (not included) to the
5
(6) Replace handle and wall plate onto valve assembly. Slide wall plate back onto the trim sleeve.
6
(7) After installation is complete, turn the water supply back on and allow both hot and cold water to
I
NSTRUCTIONS
specific plumbing system installed on your boat).
screw behind it. Slide handle off the cartridge. Slide wall plate off the trim sleeve. Be careful not
to damage the wall plate gasket.
Note that the brass valve is stamped with "UP". Make sure that the "UP" is on the top side when
positioned.
NPT-Female tubes on the left and right sides of the valve. Wrap the fittings with Teflon
(Plumber's) tape. This procedure will vary depending on the specific plumbing system installed on
your boat.
shower head (top) port. Wrap the fitting on the water line with Teflon (Plumber's) tape. Thread
tub port plug into the tub port (bottom) (if you are not using a tub spout with this installation).
Wrap the plug with Teflon (Plumber's) tape.
Be careful not to damage the wall plate gasket. Tighten the handle screw and replace the blue/
red cap. It may be necessary to secure the valve inside the wall to prevent movement. This
procedure will vary depending on the specific design of your boat. Suggestions: Use the screw-
holes molded into the valve. Use strapping material. Wedge item in place.
run for at least one full minute. While water is running, check all connections for leaks.
Connections may need re-tightening.
134-0102-CP
Stasis
Single Handle Shower
Chrome
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for SHURflo Stasis 134-0102-CP
Summary of Contents for SHURflo Stasis 134-0102-CP
- Page 1 134-0102-CP NSTALLATION NSTRUCTIONS Stasis Single Handle Shower OEM Version Chrome Attention Manufacturers: Please include this Installation Instruction sheet with your Owner’s Documentation. (1) Turn off the water supply to your existing faucet (this procedure will vary depending on the specific plumbing system installed on your boat). (2) Remove handle and wall plate from valve assembly.
- Page 2 "tested good" units. Warranty returns will be shipped on a freight allowed basis. SHURflo reserves the right to choose the method of transportation. SHURflo is not responsible nor will it reimburse for labor necessary to remove and reinstall a faucet or accessory, if found defective.
Need help?
Do you have a question about the Stasis 134-0102-CP and is the answer not in the manual?
Questions and answers