iOttie Easy One Touch 6 Manual

Product Information

At a Glance

Product Specifications

*Telescopic arm extends from 5"–7.5".

Installation

Assembling the Mount

1. Connect the mount cradle to the ball joint.
   
2. Tighten thecradle knob.
   

Attaching the Mount

Choose an installation method: dashboard/flat surface (A) or windshield/curved glass (B).
If your vehicle has a leather dashboard, we recommend windshield mounting to avoid damaging your dash.

[ Option A ]
Dashboard or Flat Surface Installation
Choose a flat location on the vehicle's dashboard and wipe any dust or debris from the surface.

1. Peel off the film on the dashboard pad and evenly press onto the desired installation location. Wait at least 20 minutes before attaching the mount to ensure a secure hold.
   
2. Remove the plastic cover from the suction cup and firmly press the mount onto the dashboard pad.
   
3. Push the locking lever down to engage suction.

*The dashboard pad is mounted with a semi-permanent adhesive tape. Once removed, it cannot be re-mounted.
*When mounting, it is recommended that the surface and product be above 65°F.
*When removing the dashboard pad, please use caution. We recommend removing slowly from the edge to avoid damage.

[ Option B ]
Windshield or Curved Glass Installation
Choose a location on the windshield and wipe any dust or debris from the surface.
The dashboard pad is not recommended for windshield mounting.

1. Peel off the protective film on the suction cup and press the mount firmly onto the windshield.
   
2. Pushing the locking lever down to engage suction.
   *To reuse the suction cup, simply rinse under warm water and let air dry to restore tacky suction.
   

Easy One Touch Mechanism

The Easy One Touch lock and release mechanism makes it simply to mount and retrieve your smartphone in seconds.

[ Mounting ]

1. Squeeze the release bars.
   
2. Press your device against the Easy One Touch trigger button. The mount's arms will automatically close on contact.
   

[ Releasing ]
Squeeze the release bars again to release your device.

Adjusting the Mount

Cradle Knob
To rotate the cradle, loosen the cradle knob. Tighten to lock into desired position.

Telescopic Arm
To extend the arm, simply pull it outward and slide it into desired position.

Bottom Foot
The foot can be adjusted up and down to fit any size phone by pulling down or pushing up.

Pivot Knob
Turning the pivot knob allows you to adjust the telescopic arm. Tighten to secure the arm in place.