Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Tool Shed TSAG17
Summary of Contents for Tool Shed TSAG17
- Page 1 ANGLE GRINDER 230MM 2300W TSAG17 www.thetoolshed.co.nz...
-
Page 2: Table Of Contents
TABLE OF CONTENTS PRODUCT DETAILS Product Details Product Model ToolShed Angle Grinder 230mm 2300W Specifications Product Identification Product Code TSAG17 Safety Guidelines Operation Maintenance Exploded Parts List DISTRIBUTED BY: Thank You Note: For the purchase of this ToolShed product. We try our hardest to supply customers like you This manual is for your reference only. -
Page 3: Specifications
OPERATION MANUAL OPERATION MANUAL SPECIFICATIONS PRODUCT IDENTIFICATION Disc Diameter 180–230mm Ø Voltage 220–230 Volts Frequency 50/60 Hertz Rated Power 2200 Watts Currency when Loading 9.9 Amps No Load Speed 6000–8000 RPM Net Weight 6.0 kg Spindle Lock Protective Guard Auxiliary Handle On/Off Paddle Switch Rotatable Rear Handle Power Cord... -
Page 4: Safety Guidelines
OPERATION MANUAL OPERATION MANUAL SAFETY GUIDELINES SAFETY GUIDELINES Electrical Safety Power Tool & Machinery Use & from moving parts in the machine, or they WARNING could become caught therein. Care • DO NOT use the power tool or machinery • Always remain alert and DO NOT operate in rainy conditions or wet areas where the •... - Page 5 OPERATION MANUAL OPERATION MANUAL SAFETY GUIDELINES SAFETY GUIDELINES • Service Angle Grinder Specific Safety Keep the cord behind the grinder and away WARNING from the work area while using the tool to • • Have your tools and machinery serviced Do not operate the power tool near flam- avoid damaging the cable and wires.
-
Page 6: Operation
OPERATION MANUAL OPERATION MANUAL OPERATION OPERATION Multi-Position Handle (Fig. 1) Changing the Disk (Fig. 4) ON/OFF Switch (Fig. 6) • • • Always use the side handle during operation Fix the inner flange to the spindle, place the To use the grinder, depress the paddle switch of the grinder to ensure the safest and easiest disk on top of the inner flange, then put the as the ON position. -
Page 7: Maintenance
OPERATION MANUAL OPERATION MANUAL OPERATION MAINTENANCE • Best Usage Practices Replacing the Carbon Brushes Before cleaning or performing any mainte- nance, you must ensure the tool is switched • • Let the tool run for 30 seconds before When the carbon brushes wear out, the angle off and disconnected from the power supply. -
Page 8: Exploded Parts List
TSAG17 EXPLODED VIEW & PARTS LIST Wheel Gear Circlip 14 Oil Bearing Side Handle Screw ST4.8×40F X4 Spindle Lock Lock Spring Circlip 6 Bumper Gear Box Fixing Screw M8 Pinion Gear Bearing 6201 6201 Bearing Cover EXPLODED PARTS LIST Spring Washer 4 X3 Screw M4×12 X3...
Need help?
Do you have a question about the TSAG17 and is the answer not in the manual?
Questions and answers