Advertisement
Quick Links
Advertisement
Related Manuals for Patiova Ridge Playset
Summary of Contents for Patiova Ridge Playset
- Page 1 Ridge Playset ASSEMBLY MANUAL PATIOVA.COM 610-857-1359 6649 North Moscow Rd Parkesburg, PA 19365...
-
Page 2: Tools Required
Thank you for your Patiova Playset Purchase. We are excited for the great times and memories you will share while enjoying your new Patiova playset. Let’s gets started on the assembly!! This manual is designed to simplify the assembly process with step-by-step instructions and pictures to help along the way. - Page 3 Hardware 5/16 x 6” Bolt 5/16 x 4 1/2” Bolt 5/16 x 4” Bolt 5/16 x 5” Hex Head Lag 3” Star Head Lag 3” Wood Screw 2 1/2” Wood Screw 1 3/4” Washer Head Screw 1 1/2” Poly Screw 1 1/2”...
- Page 4 Step 1. Step 2. Begin the assembly by locating two side frames. Place two 2x6’s on either side of the tower and fasten them to the Place them upright approximately 48” apart. 4x4 posts with 3” star head lags. Step 3. Step 4.
- Page 5 Step 5. Step 6. Fasten the 2x4 floor joists to the 2x6’s using 3” wood screws Place the two 2x4 railing pieces on either side of the tower and through the pre-drilled holes. fasten them to the 4x4 posts with 3” star head lags. Step 7.
- Page 6 Step 9. Step 10. Place a 48” 2x4 on top of the upright 2x4’s and center it both ways. Place the tarp roof over the roof frame and stretch it out to fit. Fasten it with 3” wood screws. Fasten one side first using 3/4” washer head screws then stretch the other side tight and fasten it with the same screws.
- Page 7 Swing Frame Step 1. Lay the end post on the ground then place the ground runner 2x4 on top of it. Center the 2x4 and fasten it with 3” star head lags. Step 2. Step 3. Place the two 2x4 braces on either side of the end post as shown Fasten the top of the 2x4 braces to the end post using above.
- Page 8 Step 4. Step 5. Locate the swing beam and place it on the ground with the Place two metal support plates on one end of the beam and align bearings facing up. them with the pre-drilled holes. Fasten the plates to the swing beam with two 3 1/2” bolts, washers and nuts.
- Page 9 Step 8. Step 9. Place the swing frame on the tower against one of the 4x4 posts. Use a 3/8” drill bit to drill through the 4x4 post using the holes in the swing beam as a guide. Step 10. Step 11.
- Page 10 Accessories Wave Slide. Place the slide in position on the tower then fasten it with 1 1/2” wafer head lags. Wood Ladder Wood Ladder Place the wood ladder next to the slide. Fasten the wood ladder to the tower using two 2” wood screws.
- Page 11 Rock Wall Rock Wall Place the rock wall on the back of the set and center it. Fasten the rock wall to the tower using four 3” star head lags. Playset Stakes Playset Stakes The playset comes with a bundle of stakes and hardware. Drive the stakes into the ground at each corner of the playset and fasten them with the included lags.
Need help?
Do you have a question about the Ridge Playset and is the answer not in the manual?
Questions and answers