JOLT JMS68 Instruction Manual

Stun Activation Button
Test Probes
LED Flashlight
Contact Probes
CHARGING THE BATTERIES
1. The rechargeable batteries are already installed. The unit cannot be opened, as this will void the warranty.
2. Before use, the stun gun will need to be charged. To charge, slide out the charger and plug into a
standard wall outlet. It takes approximately 8 to 10 hours to fully charge. CHARGING LONGER THAN
TEN HOURS WILL LESSEN THE BATTERY LIFE AND VOID THE WARRANTY. Every 2 months, the unit
should be charged or when the spark or light is noticeably weaker.
USING THE FLASHLIGHT
1. Slide the Safety Switch located on the side of the unit up to the middle position to turn on the LED
Flashlight.
2. Slide the Safety Switch down to turn off the light.
TESTING THE STUN GUN
(WARNING: Do not test fire the stun gun for more than 3 seconds as this will damage the unit and void the warranty.)
1. Slide the Safety Switch located on the side of the unit up to the top position to turn off the safety. The Stun
Warning Light above the Safety Switch will illuminate.
2. Press the Stun Activation Button on the side of the unit (above the Safety Switch) to test the stun
gun. You will see and hear an electrical charge fire across the top of the unit between the Test Probes.
3. When test firing the unit, do not hold the button down for more than 3 seconds. Slide the Safety Switch
down to the bottom position to turn the safety back on. The Stun Warning Light will turn off.
JMS68
Instruction Manual
Stun Warning Light
Safety Switch
Charger
Rev 03/02/2021