Page 1
Glass Patio Pet Door Product codes: #5075, #5078, #5076, #5079, #5077, #5080 IMPORTANT! READ AND INSTALLATION INFO FOLLOW THESE INSTRUCTIONS CAREFULLY AND KEEP FOR FUTURE REFERENCE.
TABLE OF CONTENTS TOOLS REQUIRED (NOT INCLUDED) Scissors Phillips Head Screwdriver Pen or Marker Drill with Phillips Head Drill Bit (Secure Install Only) Flat Head Screwdriver (Flap Adjustment Only) SAFETY INFORMATION Warnings Pre-Install Check WHAT’S IN THE BOX Parts List INSTALLATION Patio Pet Door Assembly Test Fit &...
WARNINGS INSTALLATION WARNING Please read these cautions and notes carefully before attempting installation. For any questions or concerns, contact Customer Support at www.hakunapets.com/help. If your home has children as well as pets it is important to remember that children can misuse the pet door and gain access to potential hazards on the other side.
PRE-INSTALL CHECK WHATS IN THE BOX Extensions (Sold Separately) It is advised to check the height of the sliding door prior to install. There are several different extensions to support the type of install required. See page 8 for extension installation guide. Bottom Riser Middle Glass Top Aluminium...
WHATS IN THE BOX Parts List (Foam = 3m / 9.8ft) GENERAL FITMENT Upper Frame Lower Frame Locking (Rubber = 3m / 9.8ft) Panel Locking Panel Joiner Tube Spanner Pack Out Foam Strip Foam Weather Seal Frame Joining Rubber Air Gap Seal Bolts Tube Spanner Frame Joining Bolts...
INSTALLATION Patio Pet Door Assembly WARNING: This product consists of GLASS. Handle with care. Ensure that the Lock Bolts are facing up. Place the Upper Frame, Joiner and Insert the Joiner into Lower Frame flat on the ground. Lower Frame. Slide the Upper Frame and Firmly tighten all 4 Frame Joining Lower Frame together.
INSTALLATION Test Fit & Temporary Install A temporary install is for situations where: You can’t modify the door (i.e screw / drill), it needs removal frequently or your sliding door is most secure without Patio Pet Door installed . NOTE: Test fit is required prior to secure install. WARNING: Top piece will spring upwards...
INSTALLATION Check Install Is the Patio Pet Door too short? If the door does not reach the required height, extensions are available to increase the height. A. Top Aluminium Extension (Sold Separately) Slide Top Extension on top of door. Use the supplied Bolt to screw in place securely.
Page 9
INSTALLATION Check Install Is the Patio Pet Door wobbling? If the door is moving in the sliding door frame, follow these steps. 1. Ensure the top piece is moving freely into the channel and is applying adequate pressure. Loosen and re-tighten Lock Bolts if necessary.
INSTALLATION Secure Install (Optional) A secure install ensures the sliding door can lock onto the Patio Pet Door. This is ideal for long-term use and offers a stable and secure install. 1. Determine the type of locking mechanism on the sliding door. Internal Locks External Locks All locks that are built into...
INSTALLATION Internal Lock Side Install Unscrew the locking hook on the Insert the locking hook into the lock sliding door frame. of the sliding door. Insert the Patio Pet Door into the door Close the sliding door against frame, ensuring that the Lock Bolts are the Patio Pet Door.
INSTALLATION External Lock Side Install Use Lock Bracket Pack Unscrew the lock catch from Install the lock catch onto the sliding door frame. Lock Bracket with Bolts provided. Place flat on the ground. Slide 3x Bolts into Patio Pet Door track and place Lock Bracket on top noting the lock position.
INSTALLATION Frame Side Install Use Frame Bracket Pack Loosen Lock Bolts and remove the Mark 3x drill holes evenly inside Patio Pet Door from the door frame. the door frame. Drill in the Frame Brackets into the door Insert the Patio Pet Door into the frame with the large self-tapping screws.
INSTALLATION Weather Seal & Air Gap Seal It is recommended to install a Weather Seal and Air Gap Seal to close any gaps or drafts once the Patio Pet Door is installed. For maximum adhesion, clean surface with isopropyl or water. TIP: NOTE: For internal locks, cut the seal with...
INSTALLATION Flap Adjustment & Replacement Using a flat head screwdriver, pry open Remove the screws at the top of the metal strip/bar that clasps the flap the frame securing the flap. in place. Insert/adjust flap position in frame. Push down the strip/bar to clasp the flap in place and secure with screws.
ACCESSORIES Spare Parts Scan the QR code for spare parts info or if you require further assistance please contact us at: hakunapets.com/contact-us Bar Lock Black #5011 White #5012 Bottom Riser Extension Black: Small - #5096 / Medium - #5097 / Large - #5098 White: Small - #5093 / Medium - #5094 / Large - #5095 Middle Glass Extension Black: Small - #5090 / Medium - #5091 / Large - #5092...
TRAINING TRAINING PREPARATION Determine if your pet is more motivated to go inside or outside eg. If your pet loves outside, train from inside to outside space TRAINING STEPS Step 1. One-Way Practice • Ensure the pet door flap is held / supported fully open •...
WARRANTY CERTIFICATE Congratulations! You have made an excellent choice of this quality product. Our commitment to quality also includes our service. Should you, contrary to expectations, experience defects due to manufacturing faults, we will provide you with a warranty against defects as follows: WARRANTY The product is guaranteed to be free from defects in workmanship and parts for a period of 5 years from the date of purchase.
Page 20
Thankyou ! for making a purchase with Hakuna Pets. Providing our customers with a positive experience is our #1 priority and we value your feedback. If you have anything less than 5 star satisfaction or you require any assistance with spare parts please contact us directly at:...
Need help?
Do you have a question about the 5075 and is the answer not in the manual?
Questions and answers