• Avoid obstructions such as plumbing or electrical wires EQUIPMENT DAMAGE MAY OCCUR IF INSTALLATION when cutting into walls. INSTRUCTIONS ARE NOT FOLLOWED. • Connect Model 300 Series power cord only to 120 VAC, 60Hz. Follow all state and local codes regarding electrical CAUTION wiring.
LOCATION Locate the unit close to a drain and where temperatures do not The Model 300 can be located in a utility closet, laundry room, reach freezing, such as a laundry room, basement, utility closet, basement, or any space where the unit can be mounted to etc The unit is rated for 70°F intake air;...
Page 4
To install parallel to joist, attach the angle supports to the If this is a finished ceiling, or you wish to install the humidifier middle holes in the housing with the #8 x 1/2” screws provided. perpendicular to the joists, attach the angle supports to the If distance between joists is less than 14.5”, top mounting holes top holes in the housing.
AIR DISTRIBUTION AND EVAPORATIVE CAPACITY Check all state and local codes and proper design regarding The Model 300 has the capacity to deliver 250 CFM at air distribution systems 01” wc, equivalent to an effective duct length of 80 feet The...
140°F, but they often will not be activated by the Model will take about 10 minutes 300 due to its low flow rate.) Use 1/2” ID plastic hose for the drain Be sure that the water heater has sufficient capacity and...
WIRING POWER FIGURE 6: WIRING The Model 300 is prewired internally and equipped with a 120 VAC cord and plug A. POWER CORD D. CAPACITOR B. HUMIDISTAT E. FAN C. PCB ASSEMBLY F. SOLENOID HUMIDITY CONTROL The AprilAire Model 65 Humidifier Control is designed for 24 VAC to control humidification equipment.
Need help?
Do you have a question about the 300 and is the answer not in the manual?
Questions and answers