Advertisement
GIANT EXPRESSWAY FOLDING GUIDE
Thanks for purchasing the Giant Expressway folding bicycle. This guide will help you properly fold
and unfold your Expressway. Please read it thoroughly along with the Giant Owner's Manual.
NOTE: bEfOrE ridiNg yOur ExprEssway fOldiNg bicyclE fOr ThE firsT TimE,
makE surE TO familiariZE yOursElf wiTh ThE lOcaTiON aNd OpEraTiON Of all
ThE quick rElEasE lEvErs.
SEAT POST QUICK RELEASE
FRAME FOLDING QUICK RELEASE
SEAT POST QUICK RELEASE
Open the sEaT pOsT quick rElEasE lever (FIG. 1) and raise or lower the seat post to the
correct height. The seat post has an etched or stamped mark on its shaft which designates the post's
"Minimum Insertion" or "Maximum Extension." This mark must not be visible above the quick release.
Close the sEaT pOsT quick rElEasE lever securely, making sure the seatpost does not slip.
STEM HEIGHT QUICK RELEASE
Open the sTEm hEighT quick rElEasE lever (FIG. 2) and raise or lower the stem to the correct
height. The stem has an etched or stamped mark on its shaft which designates the stem's "Minimum
Insertion" or "Maximum Extension." This mark must not be visible above the quick release. Close the
sTEm hEighT quick rElEasE lever securely, making sure the stem does not slip.
HANDLEBAR ROTATION QUICK RELEASE
Open the haNdlEbar rOTaTiON quick rElEasE lever (FIG. 3) and rotate the handlebar to a
comfortable position, making sure the brake levers are within easy reach. Close the haNdlEbar
rOTaTiON quick rElEasE lever securely, making sure it does not slip.
FIG. 1
FIG. 2
HANDLEBAR ROTATION
QUICK RELEASE
STEM HEIGHT QUICK RELEASE
STEM FOLDING QUICK RELEASE
FIG. 3
1. before each ride, check to make sure all quick release levers are closed and properly
secured.
2. do not over-tighten the quick release levers. always hand-tighten until clamping is
snug. Never use a tool or wrench to tighten the quick release levers.
3. Never ride the bicycle if the frame is damaged or the quick release levers are loose
or damaged.
4. Never ride the bicycle with the seat post or stem extended beyond the "minimum
insertion" or "maximum Extension" mark.
5. Never ride the bicycle if the handlebar continues to rotate after the haNdlEbar
rOTaTiON quick rElEasE has been closed.
FOLDING INSTRUCTIONS
STEP 1
Rotate the crank set so that the pedal on the drive side (right side) of the bicycle is even with the
chain stay (FIG.4). Then, fold both pedals by first pulling in on the spring-loaded release inside the
pedal and then folding down (FIG 5).
FIG. 4
FIG. 5
STEP 2
Open the STEM FOLDING QUICK RELEASE lever (FIG. 6) and fold the handlebar/stem assembly
downward (FIG. 7 and 8).
FIG. 6
FIG. 7
caution
FIG. 8
Advertisement
