Advertisement
Water Cooler
Dispenser with Filtration
System
Operation Manual
FLOOR STANDING TYPE
OHC-500U
Stock Code: 1200746
COUNTERTOP TYPE
OHC-200U
Stock Code: 1200751
Please read this Operation
Manual carefully prior to
installation. Then, keep it
in a secure place for future
reference
Manufactured for EPS Group
Manufactured for EPS Group
Advertisement
Table of Contents
Related Manuals for EPS OHC-500U
Summary of Contents for EPS OHC-500U
- Page 1 Water Cooler COUNTERTOP TYPE Dispenser with Filtration OHC-200U System Stock Code: 1200751 Operation Manual Please read this Operation Manual carefully prior to installation. Then, keep it in a secure place for future reference Manufactured for EPS Group Manufactured for EPS Group...
- Page 2 Introduction The EPS Water Cooler Dispenser enhances any setting, whether it's an office, spa, salon, or home, providing easy access to filtered water. Available in countertop and floor-standing models, both connect effortlessly to your mains water supply using a standard 1/4-inch connection pipe, ensuring a simple installation process.
-
Page 3: Safety Instructions
Safety Instructions Warnings Cautions Designed for indoor use exclusively. Avoid Place the Point Of Use (POU) cooler on a flat installing the POU cooler in areas with high and sturdy surface during installation. Failure humidity, low temperature, or poor to do so could result in the POU cooler ventilation. -
Page 4: Specifications
Chilled water switch Chilled water faucet Drip tray Front lower panel Specifications Product Name Water Cooler Dispenser with Filtration System Model Number OHC-500U Dimension(mm) 260(W) x 462(D) x 1120(H) Net Weight 22kg Rated Voltage 220-240V / 50Hz Power Consumption 100W (cooling) Dispense Water Temperature Below 12°C (Cold) - Page 5 Name of Each Component & Specification Chilled water switch Ambient water faucet Cold water faucet Drip tray Specifications Product Name Water Cooler Dispenser with Filtration System OHC-200U Model Number 260(W) x 462(D) x 521(H) Dimension(mm) 17kg Net Weight Rated Voltage 220-240V / 50Hz Power Consumption 100W (cooling)
-
Page 6: Installation Instructions
How To Install & Operate IMPORTANT! Install pressure reducing valve for the feed pressure above 4 bar. We strongly advise having the POU cooler installed by a trained professional. Please note: The installation kit is not provided with the POU cooler. You will need a ¼... - Page 7 Before You Start & How to Use How to operate Please read this section carefully! 1. Open the water supply valve. The valve must be open for the POU cooler to function properly. 2. When the lamp on the front goes out. If the lamp on the front goes out, please check to see if there was power cut off or other reasons that blocks electricity supply.
-
Page 8: Maintenance
Maintenance Cleaning the POU Cooler 1. Close the water providing valve and turn the switch to OFF. 2. Unplug the power. 3. Drain the cold water from the tank. 4. Take the back panel off by unscrewing the screws on the back and take the cold water tank cover. -
Page 9: Troubleshooting Guide
Troubleshooting Guide Please check the following items prior to asking for repair Troubles Things to check Troubleshooting Plug in the power plug to the grounded outlet. Is the power supply? Turn on the cold water switch on the Is the cold water lamp off? back.
Need help?
Do you have a question about the OHC-500U and is the answer not in the manual?
Questions and answers