Designplan LUCE SU FERRO Quick Start Manual

LUCE SU FERRO
1.2W, 120VAC
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO
PERSONS. READ ALL INSTRUCTIONS. IMPORTANT SAFETY
INSTRUCTIONS. SAVE THESE INSTRUCTIONS.
DANGER - RISK OF SHOCK - DISCONNECT POWER BEFORE
INSTALLATION! Please read all instructions before installation.
• Keep these instructions for future reference.
Must be installed by a qualified electrician in accordance with national and
•
local standards. Designplan is not responsible for fixtures installed without
regard to these standards.
• The main power connection must be in accordance with local electrical codes.
Unauthorized alterations or tampering of product voids warranty.
•
Suitable for INDOOR applications.
•
ATTENTION:
For Surface - It is the contractor's responsibility to caulk around all the edges between
the fixture and the mounting surface to satisfy wet label requirements.
Maintenance
Scheduled maintenance must be carried out once a year on all lighting devices, regardless of appliance
class and type of use. It must include the following operations:
• Periodically clean fixtures to remove dirt from gratings and screw heads.
• Check tightness of screws on various parts of the device.
• Check that all cable glands and cables are intact and tight. Check that the glass or plastic lens is intact,
and replace it if broken or damaged.
• The internal components such as the ballast, driver, washers and screws must not show clear signs of
oxidation or rust. Clear traces of rust and oxidation will indicate the presence of water inside the device.
• In the case of damage, the components must be replaced by original components or spare parts.
sales@designplan.com
www.designplan.com
79 Trenton Avenue, Frenchtown NJ 08825
© Copyright 2025 Designplan Lighting, Inc.
installation instructions
IP20
P: 908-996-7710
F: 908-996-7042
1 of 2