Designplan ACQUASTOP BRIGHT 2.6 Installation Instructions

BRIGHT 2.6 - 2.7
Installation instructions
IP67
3.15"
3.35"
3.15"
-ACQUASTOP-
Kg0.50
3.35"
3.35"
Designplan Lighting, Inc., 79 Trenton Ave., Frenchtown NJ, 08825. T.908-996-7710 F.908-996-7042
Designplan Lighting, Inc., 79 Trenton Ave., Frenchtown NJ, 08825. T.908-996-7710 F.908-996-7042
Please read the following instructions carefully.

IMPORTANT:

•
Although LED runs on a very low voltage, always cut off the power sup-
ply before installing the LED light or subjecting it to maintenance.
• Unauthorised alterations or tampering of the product will invalidate all
the conditions of guarantee.
This fixture must be installed by a qualified electrician.
•
Designplan is not resposable if its fixtures are not installed in
•
according to local safety standards.
• Data contained in this document may be changed at any moment with-
out prior notice.

ELECTRICAL CONNECTIONS:

• LED lights run at constant current.
•
LED lights must be connected in parallel respecting polarities.
•
As for the choice of the power supplies, please consider the tension
through which they are fed and the max power consumption of
LEDs you have to install.
•
The system must be fed only if all the spots are connected.
• The power supplies must be installed in aerated rooms, far from heat
sources. A situation of overworking or a lack of air circulation will not
permit a natural dissipation.
• Under no circumstance must this product be covered by thermalisolating
material or similar.
NOTES:
Wire connections must be made with water-proof wire
•
nuts or similar.
Pag. 1 - rev.00

WARNING!!!

+DESIGN