Hunter 21100 Owner's Manual And Installation Manual page 16

7 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Uninstalling the Light Fixture
7-14. To uninstall the light fixture, first disconnect the plug
connectors between the black wire and the black wire with a
white stripe wire.
7-15. Disconnect the plug connectors between the two white
wires.
7-16. Remove the two screws attaching the light kit to the lower
switch housing.
7-17. Remove the light fixture from the lower switch housing,
pulling disconnected wires through the hole in the center of
the lower switch housing.
Note: When removing the wires, pull the thin plug
connector (male) through first, and then pull the other plug
connector (female) through the hole.
7-18. Install the dummy terminals (included in the sack parts) on
the two disconnected wires in the lower switch housing.
7-19. Install the switch housing cap and plug button to the lower
switch housing.
7-20. Once you have uninstalled the light fixture, continue
with step 7-6.
Male Dummy
Female Dummy
Terminal
Terminal
16
45055-01 • 02/24/11 • Hunter Fan Company
Lower Switch
Housing
Step 7-16
Cap
Plug Button
Step 7-19