RCA RP3710 - AM/FM Clock Radio User Manual page 7

Operating the Clock
Turning off Alarm
EN
Silence the alarm momentarily
Press SNOOZE. The alarm will sound again
when the snooze period is over. (see
"Snooze Alarm Operation").
Stop the alarm
Press OFF. Then the alarm will be on the
following day at the same time.
Disable the alarm permanently
1. Press CANCEL button.
2. The WAKE 1 and WAKE 2 indicator will
be flashing.
3. Press WAKE 1 or WAKE 2 button within
3 seconds to deactivate the alarm function
permanently, "OFF" will be shown when
the above procedures are done.
Tip: You can activate the previously
set alarm time by pressing WAKE 1
WAKE 2 WAKE 2 button. WAKE 2
WAKE 2 WAKE 2
Snooze Alarm Operation
This operation allows extra sleep time af-
ter the alarm is on. The alarm will be off
by pressing SNOOZE until the snooze pe-
riod is over. Snooze function can be used
repeatedly up to 2 hours. After this, the
alarm will yurn off until the next alarm
conditions are met. Set the "quiet time"
as follow:
6
RP3710 EN
1. Press and hold SNOOZE.
2. Press REV or FWD to set the "quiet"
period (the default time is 9 minutes) from
1 minute to 30 minutes. Release button,
then the "quiet" period is set.
Seconds Time Display
The unit may display in seconds.
1. The clock should be in normal mode.
2. Press
seconds display.
3. Release to return to the hour and
minute display.
Brightness control
You can adjust the backlight by the
BRIGHTNESS button, there are three
modes you may select from:
OFF - Backlight always off.
WAKE 1 WAKE 1 or WAKE 1
WAKE 1
HIGH - Backlight always high.
LOW - Backlight always low.
7
or to show
3/3/03, 4:30 PM