This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
In accordance with FCC requirements, changes or modifications not expressly approved by
Thomson multimedia Inc. could void the user's authority to operate this product.
This device generates and uses radio frequency (RF) energy, and if not installed and used
properly, this equipment may cause interference to radio and television reception.
If this equipment does cause interference to radio or television reception (which you can
determine by unplugging the unit), try to correct the interference by one or more of the
• Re-orient the receiving antenna (that is, the antenna for the radio or television that is
"receiving" the interference).
• Move the unit away from the equipment that is receiving interference.
• Plug the unit into a different wall outlet so that the unit and the equipment receiving
interference are on different branch circuits.
If these measures do not eliminate the interference, please consult your dealer or an experienced
radio/television technician for additional suggestions. Also, the Federal Communications
Commission has prepared a helpful booklet, "How To Identify and Resolve Radio TV Interference
Problems." This booklet is available from the U.S. Government Printing Office, Washington, DC
20402. Please specify stock number 004-000-00345-4 when ordering copies.
This product complies with DHHS Rules 21 CFR Subchapter J. Applicable at the date of
TO PREVENT FIRE
OR ELECTRICAL SHOCK HAZARD,
DO NOT EXPOSE THIS PRODUCT
TO RAIN OR MOISTURE.
This product should be serviced only by those specially trained in appropriate servicing
techniques. Attach your sales receipt to the booklet for future reference or jot down the date
this product was purchased or received as a gift. This information will be valuable if service
should be required during the warranty period.
Purchase Date _________________________
Name of Store ________________________
RP3755 EN-US rev.2
RISK OF ELECTRIC SHOCK
DO NOT OPEN
T H E
L I G H T N I N G
CAUTION: TO REDUCE THE
FLASH AND ARROW-
RISK OF ELECTRIC SHOCK,
POINT WITHIN THE
HEAD WITHIN THE
D O N O T R E M O V E C O V E R
T R I A N G L E I S A
T R I A N G L E
( O R B A C K ) . N O U S E R -
W A R N I N G
S I G N
ALERTING YOU OF
S E RV I C E A B L E PA R T S I N -
ALERTING YOU OF
I M P O R T A N T
S I D E . R E F E R S E R V I C I N G
" D A N G E R O U S
T O Q U A L I F I E D S E R V I C E
I N S T R U C T I O N S
A C C O M P A N Y I N G
T H E
P R O D U C T .
SEE MARKING ON BOTTOM / BACK OF PRODUCT
AC OUTLET POWER SUPPLY: 120V ~60Hz
Power is fed to the unit even when it is not functioning. To cut
the power supply off, the power cable must be unplugged.
For Your Safety
The AC power plug is polarized (one blade is wider than the other) and only fits into AC power
outlets one way. If the plug won't go into the outlet completely, turn the plug over and try to
insert it the other way. If it still won't fit, contact a qualified electrician to change the outlet, or
use a different one. Do not attempt to bypass this safety feature.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT,
This clock radio is equipped with a memory holding system that can be powered with a 9-volt
battery (not included). The power failure protection circuit will not operate unless battery is
When normal household power is interrupted, or AC line cord is unplugged, the back-up battery
will power the clock radio to keep track of time and alarm settings programmed into memory.
When the battery backup functions, the function of alarm still occurs during the power
interruption if remaining battery power is adequate. Normal operation will resume after AC
power is restored so you will not have to reset the time or the alarm. With battery back-up, if
Wake to Radio or Wake to CD is activated during power interuption, Wake to Tone will operate
instead. Wake mode will operate normally again once power is resumed.
When AC power is interrupted (disconnected) for a short period of time, both time and alarm
settings will change (unless optional battery is installed). After AC power is restored
(reconnected), the Digital Display will blink to indicate that power was interrupted and you
should readjust the time and alarm settings.
Have a Blast- Just Not in Your Eardrums!
Make sure you turn down the volume on the unit before you put on headphones.
Increase the volume to the desired level only after headphone are in place.
The descriptions and characteristics in this owner's manual are for the purpose of general reference only and not as
a guarantee. In order to provide you with the highest quality product, we may make changes or modifications
without prior notice. The English version serves as the final reference on all product and operational details should
any discrepancies arise in other languages.
6/21/01, 2:37 PM