Hasbro GIJOE THEREAL AMERICANHERO A.W.E. STRIKER 57768 Quick Start Manual

i
THE REAL AMERICAN HERO ™ COLLECTION
A.W.E. STRIKER"
Some assembly required- no tools necessary.
Remove all pieces from plastic frames.
If you have difficulty, use safety scissors.
Ages 5
&
Up
57768
A
WARNING:
CHOKING HAZARD-Small parts.
Not for children under 3 years.
With posts on front suspension facing up, insert spindles into holes as Place rear suspension bar into notch on rear of chassis as shown (2A). Swing suspension
shown. Snap into place. Place one hole in steenng linkage onto spindle post. under chassis and snap ends of leaf springs behind seats (2B).
Place other hole in steering linkage onto other spindle post (1 A). Snap center
hole of front suspension over tab on front of chassis (IB).
Insert tab on front of chassis into hole on front of body. Press body so tabs snap Insert tab on engine half into slot in other engine half. Snap together (4A). Fit hole in
behind seats. With lug nuts facing out, snap tires onto 4 axle posts. engine over post and tab in engine compartment as shown (4B). Engine is
removeable for pretend repair.
With tab on steering wheel facing up, snap into hole in dashboard (5A).
With camera scope facing forward, hold camera bar in slot above passenger seat.
(5B). While holding camera in place, fit tabscn dashboard into notifies on
sides of body. Snap dashboard forward to trap camera in place (5C).
Place front tabs on roll bar into slots on sides of hood. Insert 4 posts into holes in middle
and rear of vehicle.
Insert post on cannon half into hole in other cannon half. Snap ends of cannon Press lenses into holes in bumper. Snap bottom of bumper onto tab on front of vehicle,
together. Insert thin side of cannon pintle into slot in bottom of cannon. Snap into Snap posts on antennas into holes on sides of roll bar. Place 2 tabs on engine cover
place (7A). Snap cannon cap onto front of cannon. Insert cannon pintle into hole on under ledge in back of vehicle. Snap into place,
top of roll bar. Fit one end of remote control cable onto post on side of camera. Fit
other end over post on side of roll bar (7B).