Installation - Magnavox MCR140 - Big Display Alarm Clock Radio User Manual

CONTROLS
Top View (see fig. 1 )
1 SET TIME /ALARM OFF
- sets the clock time
- stops the active alarm for 24 hours
- switches off the radio sleep function
2 SET ALARM 1 / SET ALARM 2 - sets the alarm time for alarm 1 / alarm 2
3 AL1/ AL2 /AL1+2 - selects which alarm(s) you want to set alarm time on
4 REPEAT ALARM - switches off the active alarm for a 7-8 minutes period
5 OFF/ ON/ AUTO/ BUZZ
OFF: switches off the radio/alarm
ON: switches on the radio
AUTO: activates the radio for alarm
BUZZ: activates the buzzer for alarm
6 TIME SET 3 - to adjust time fast forward
7 TIME SET 4 - to adjust time back
8 SLEEP
- activates the radio for sleep function
- adjusts the sleep period
Front View (see fig. 2 )
9 ALARM 1 indicator - lights up when alarm 1 is activated.
0 ALARM 2 indicator - lights up when alarm 2 is activated.
! DISPLAY - shows the clock/alarm time and status of the setting
@ Frequency pointer - shows the radio frequency of your selected waveband
# PM indicator -lights up when time is PM.
English Back View (see fig. 3 )
$ Battery door - opens to store a 9 volts 6F22 battery (not included) for clock
memory backup.
% TUNING - tunes to radio stations
^ FM/AM - selects FM/AM waveband
& BRIGHTNESS (High or Low) -selects display brightness
* Power cord - for power supply and to improve FM reception
( VOLUME - adjusts the sound level

INSTALLATION

POWER SUPPLY
1 Check if the power supply, as shown on the type plate located on the bot-
tom of the set, corresponds to your local power supply. If it does not, consult
your dealer or service center.
2 Connect the power cord to the wall outlet.
3 To disconnect the set from the power supply completely, remove the
plug from the wall outlet.
SELECTING DISPLAY BRIGHTNESS
This set allows you to choose high or low brightness of display.
• Adjust BRIGHTNESS switch (located on the rear of the set) to HIGH or LOW
position.