Download
Share
Print this page
  1. Manuals
  2. Brands
  3. HEEVE Manuals
  4. Lifting Systems
  5. DRIVEWAY RUBBER KERB RAMP
  6. Installation manual

HEEVE DRIVEWAY RUBBER KERB RAMP Installation Manual

Hide thumbs
1
2
3
4
5
6
7

Advertisement

Quick Links

Download this manual
HEEVE DRIVEWAY
RUBBER KERB RAMP
I N S T A L L A T I O N G U I D E

Advertisement

loading
Need help?

Need help?

Do you have a question about the DRIVEWAY RUBBER KERB RAMP and is the answer not in the manual?

Questions and answers

Related Manuals for HEEVE DRIVEWAY RUBBER KERB RAMP

Summary of Contents for HEEVE DRIVEWAY RUBBER KERB RAMP

  • Page 1 HEEVE DRIVEWAY RUBBER KERB RAMP I N S T A L L A T I O N G U I D E...

  • Page 2: Product Specifications

    Heeve Driveway Rubber Kerb Ramp Quick and Easy to Install The Heeve Driveway Rubber Kerb Ramp in 1.2 Sections for Rolled Edge Kerb and the Heeve Premium Driveway Rubber Kerb Ramp are economical solutions to eliminate the bottoming out or scraping of your car every time you pull in or pull out of your driveway.
  • Page 3 The number of 1.2-metre sections needed depends on the width and depth of your driveway. The Heeve Premium Driveway Rubber Kerb Ramp Kits can be expanded by adding more centre modules according to the size of your driveway. You may also purchase each module separately according to your requirements.

  • Page 4: Recommended Tools

    However, if you have difficulty joining the ramps together by hand, the following tools are recommended: Step By Step Guide For Easy Installation: First, lay all Heeve Driveway Rubber Kerb Ramp in 1.2m Sections on the gutter. Centre the entire device in relation to the width of your driveway. - 4 -...
  • Page 5 Installing The Heeve Rubber Driveway Kerb Ramp Flip each section away from the kerb, upside down into the street and parallel to the gutter. Make sure all sections are in alignment and are butted tight together end to end. With safety in mind, stand on the outer receiving sections. Prepare the tools and start pushing each galvanized bolt on one ramp/section all the way to the adjacent section's holes.
  • Page 6 Installing The Heeve Rubber Driveway Kerb Ramp Once alignment is properly secured and all bolts have been hammered through, get the nuts and position them screwing with your fingers. Insert a bolt through the holes in each section using the provided hardware.
  • Page 7 Note: A standard driveway requires 3 sections but depending on the number of sections you bolted together, the Heeve Driveway Rubber Kerb Ramp now can weigh in excess of 66kg. Therefore, it is recommended that two people are available to perform the last step.