Related Manuals for HEEVE DRIVEWAY RUBBER KERB RAMP
Summary of Contents for HEEVE DRIVEWAY RUBBER KERB RAMP
- Page 1 HEEVE DRIVEWAY RUBBER KERB RAMP IN 1.2M SECTIONS I N S T A L L A T I O N G U I D E...
- Page 2 Sections for Rolled-Edge Kerb Quick and Easy to Install The Heeve Driveway Rubber Kerb Ramp in 1.2 Sections for Rolled Edge Kerb is an economical solution to eliminate the bottoming out or scraping of your car every time you pull in or pull out of your driveway. It is easy to lift by a single person to clean debris collected underneath or to relocate.
- Page 3 Recommended Tools: Step By Step Guide For Easy Installation: First, lay all Heeve Driveway Rubber Kerb Ramp in 1.2m Sections on the gutter. Centre the entire device in relation to the width of your driveway. - 3 -...
- Page 4 Installing The Heeve Rubber Driveway Kerb Ramp Flip each section away from the kerb, upside down into the street and parallel to the gutter. Make sure all sections are in alignment and are butted tight together end to end. With safety in mind, stand on the outer receiving sections. Prepare the tools and start pushing each galvanized bolts on one ramp/section all the way to the adjacent section's holes with a hammer.
- Page 5 Installing The Heeve Rubber Driveway Kerb Ramp Once alignment is properly secured and all bolts have been hammered through, get the nuts and position them screwing with your fingers. To tighten the nuts, get your ratchet and 13mm socket and start screwing the bolts through.
- Page 6 A standard driveway requires at least 3 sections but depending on the number of sections you bolted together, the Heeve Driveway Rubber Kerb Ramp now weighs approximately 66kg to 88kgs. Therefore, it is recommended that two people are available to perform the last step.
Need help?
Do you have a question about the DRIVEWAY RUBBER KERB RAMP and is the answer not in the manual?
Questions and answers