Adding Both Wps And Non-Wps Clients - NETGEAR DGND3300 - RangeMax Dual Band Wireless-N DSL Gateway Wireless Router User Manual

Adding Both WPS and Non-WPS Clients

For non-WPS clients, you cannot use the WPS setup procedures to add them to the wireless
network. You must record, and then manually enter your security settings (see
Configuring Your Wireless Settings" on page
To connect a combination of non-WPS enabled and WPS-Enabled clients to the modem router:
1. Configure the network names (SSIDs), select the WPA/PSK + WPA2/PSK radio button on the
Wireless Settings screen (see
and click Apply.
2. On the WPA/PSK + WPA2/PSK screen, select a passphrase and click Apply. Record this
information to add additional clients.
3. For the non-WPS devices that you want to connect, open the networking utility and follow the
utility's instructions to enter the SSID, WPA/PSK + WPA2/PSK security method, and
passphrase.
4. For the WPS devices that you want to connect, follow the procedure
Add a WPS Client" on page 2-11
Note: To make sure that your new wireless settings remain in effect, verify that the
Keep Existing Wireless Settings checkbox is selected in the WPS Settings
screen.
5. To view a list of all devices connected to your modem router (including wireless and Ethernet-
connected), see "Viewing a List of Attached Devices" on page
Safeguarding Your Network
RangeMax Dual Band Wireless-N Modem Router DGND3300 User Manual
"Manually Configuring Your Wireless Settings" on page
or "Using PIN Entry to Add a WPS Client" on page
v1.0, September 2009
2-4).
4-8.
"Manually
2-4).
"Using a WPS Button to
2-12.
2-15