MPH Ranger Quick Reference Manual

Lo
Some of the keys have two colors of text identifying them. The red text is the default function of the key; pressing the key by
itself will cause it to perform this function. The function in blue text is initiated by first pressing the blue "2ndF" key.
Mov/Sta: Toggles the radar between moving and stationary operating mode (Auto Stationary Mode is turned off or radar is
in tuning fork mode).
Test: Manually initiates a self-test of the radar.
Fork (2nd F Test) : Places the radar in tuning fork test
Range: Displays the numerical range of locked targets, after the radar is put in standby.
Pat Bl (2nd F Range): Alternately blanks and un-blanks a locked patrol speed when the radar is in standby.
Works with the menu button. Increases or turns on a selected menu item. If not used with the menu
Hi
:
button, places the radar into Highway mode.
Menu: Used for modes and setting that do not have individual buttons on the remote. See other side of sheet.
Works with the menu button. Decreases or turns off a selected menu item. If not used with the menu
Lo
:
button, places the radar into City mode.
2nd F: Causes the radar to select the blue second function of a key instead of the red primary function. "2nd" appears in
the middle window when it is pressed.
Backlt: (Wireless Remote) Turns on the backlight of the remote control for 7 seconds. (Wired remote) On unit power up,
backlight defaults on. After power up, "backlt" toggles remote backlight on/off.
Ranger Quick Reference Guide
Alert
Range
Fork
Hi
Embossed flat membrane keys
Raised rubber keys
The most commonly used keys, those used while driving, are
at the top of the remote. They are raised rubber keys and are
contoured so that the operator's thumb is cradled in the center
of a five-key cluster, allowing easy control of the radar's
operating mode while allowing the operator to keep his eyes
on the road. All of these keys are backlit for use at night.
Front: Places the radar into front antenna mode.
Rear: Places the radar into rear antenna mode.
Standby: Places the radar into Standby.
Opposite: Places the radar into opposite direction mode.
Same: Places the radar into same direction mode.
Lock: Causes the radar to lock the Target speed in the Lock
window. Pushing the Lock button again clears the
speed in the Lock window.
A locked target will automatically be cleared after a
pre-set time limit (see operation manual). If the unit is
in standby, a countdown will be shown in the target
window, allowing the officer time to note the speeds
before they are erased.
Alert: Turns rear alert mode on.