Safety Instructions • ALWAYS use a suitable cooking oil. • Position on a flat, stable • ALWAYS remove excess surface. moisture/water from food • A service agent/qualified before frying to avoid excess technician should carry out foaming and spitting of the installation and any repairs if oil.
Page 3
Visual Inspection, Polarity Test, Earth Continuity, Insulation Continuity and Functional Testing. • HOST recommend that this product is connected to a circuit protected by an appropriate RCD (Residual Current Device). HOST0565FS_EN_A5_v1_20220815.indb 3 HOST0565FS_EN_A5_v1_20220815.indb 3...
Installation 1. Place the unit on a heat-resistant surface. Avoid placing it on or close to flammable materials. Maintain a distance of 20cm (7 inches) between the appliance and walls or other objects for ventilation. 2. Keep the unit away from splashing water and countertop’s edge. Note: Before using for the first time, clean the lid, basket, batter plate and the oil tank with warm soapy water.
Page 5
Assembly • Press the basket handle on the clip of the basket until it locks into place. 1. Place the oil tank into the tank holder. • Now the basket handle is locked in place. 2. Place the control unit onto the tank holder, making sure the studs of the control unit rest stably on the support bracket of the tank holder.
Check the temperature with a suitable probe thermometer; 40ºC is the MAXIMUM temperature at which oil should be removed. • For best performance, HOST recommend that the appliance is cleaned after each day of operation. Note: Failure to clean the appliance regularly may result in premature activation of the thermal cut-out switch.
Oil overheats or Thermostat damaged Switch off immediately. Consult a qualified technician starts to smoke Service Should your appliance have a fault, please visit the Service section of the HOST website. Technical Specifications Dimensions Weight Model Voltage Power...
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of HOST. Every effort is made to ensure all details are correct at the time of going to press, however, HOST reserve the right to change specifications without notice.
Page 9
DocuSign Envelope ID: 0DEA8331-C8BA-4DEE-BE9E-CB841C6EC97A UKCA Declaration of Conformity {Host} {Host House, Chepstow, NP16 6UP} hereby declare that the equipment is in conformity with the requirements of the following Regulations: Electrical Equipment (Safety) Regulations 2016 Electromagnetic Compatibility Regulations 2016 ...
Need help?
Do you have a question about the HOST0565FS and is the answer not in the manual?
Questions and answers