Safety Instructions • Position on a flat, stable surface. • A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components or service panels on this product. • Consult Local and National Standards to comply with the following: - Health and Safety at Work Legislation - BS EN Codes of Practice...
Visual Inspection, Polarity Test, Earth Continuity, Insulation Continuity and Functional Testing. • HOST recommend that this product is connected to a circuit protected by an appropriate RCD (Residual Current Device). Operation ON/OFF (Green) / Heat (Red)
• Check the temperature with a suitable probe thermometer; 40ºC is the MAXIMUM Clips temperature at which oil should be removed. • For best performance, HOST recommend that Holes the appliance is cleaned after each day of Mounting operation. plate...
Clean the appliance Oil overheats or starts Thermostat damaged Switch Off immediately. to smoke Replace thermostat Service Should your appliance have a fault, please visit the Service section of the HOST website. Technical Specifications Temperature Capacity Dimensions Weight Model Voltage Power range (°C)
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of HOST. Every effort is made to ensure all details are correct at the time of going to press, however, HOST reserve the right to change specifications without notice.
Page 7
DocuSign Envelope ID: 0DEA8331-C8BA-4DEE-BE9E-CB841C6EC97A UKCA Declaration of Conformity {Host} {Host House, Chepstow, NP16 6UP} hereby declare that the equipment is in conformity with the requirements of the following Regulations: Electrical Equipment (Safety) Regulations 2016 Electromagnetic Compatibility Regulations 2016 ...
Need help?
Do you have a question about the HOST0564FS and is the answer not in the manual?
Questions and answers