Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for TOLSEN TOOLS FORCE XPRESS 88551
Summary of Contents for TOLSEN TOOLS FORCE XPRESS 88551
- Page 1 88551 DEMOLITION HAMMER INSTRUCTION MANUAL 1500W 230V~50Hz SAVE THIS MANUAL ! You will need this manual for safety instructions, operating procedures and warranty. Put it and the original sales receipt in a safe dry place for future reference.
-
Page 2: Important Safety Information
SAFETY IMPORTANT SAFETY INFORMATION General power tool safety warnings WARNING: read all safety warnings and instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term ″power tool″... -
Page 3: Demolition Hammer Safety Warnings
SAFETY Power tool use and care 1. Do not force the power tool. use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. 2. -
Page 4: Vibration Safety
SAFETY 15. People with pacemakers should consult their physician(s) before use. Electromagnetic fields in close proximity to heart pacemaker could cause pacemaker interference or pacemaker failure. In addition, people with pacemakers should: • Avoid operating alone. • Properly maintain and inspect to avoid electrical shock. •... -
Page 5: Specifications
SPECIFICATIONS SPECIFICATIONS Electrical input 230VAC / 50 Hz No load blows per minute 900--2100 /min Input power 1500W Impact joules 1 Bull Point (included) Chisels 1 Flat Point (included) SETUP - BEFORE USE Read the entire important safety information section at the beginning of this manual including all text under subheadings therein before set up or use of this product. -
Page 6: Tool Set Up
SETUP OPERATING INSTRUCTIONS Read the entire important safety information section at the beginning of this manual including all text under subheadings therein before set up or use of this product. Tool Set up WARNING! to prevent serious injury from accidental operation: Make sure that the trigger is in the off-position and unplug the tool from its electrical outlet before performing any procedure in this section. -
Page 7: Maintenance And Servicing
MAINTENANCE AND SERVICING Procedures not specifically explained in this manual must be performed only by a qualified technician. Note: the demolition hammer will cease operation once carbon brushes are worn. Check brushes every 100-120 hours and, when necessary, replace them. TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERAITON: make sure that the trigger is in the off-position and unplug the tool from its electrical outlet before performing any procedure in this section. -
Page 8: Troubleshooting
TROUBLESHOOTING TROUBLESHOOTING Problem Possible causes Likely Solutions Tool will 1. Cord not connected. 1. Check that cord is plugged in. not start. 2. Check power at outlet. If outlet is unpowered, 2. No power at outlet. turn off tool and check circuit breaker. If 3. -
Page 9: Ce Declaration Of Conformity
CE DECLARATION OF CONFORMITY SUZHOU TOLSEN TOOLS CO.,LTD. Building No.2, Zhenxing Road, Hexing, Jinfeng Town, Zhangjiagang City, Jiangsu Province, China Declare that the product 88550/88551 DEMOLITION HAMMER Complies with the essential health and safety requirements of the following Directices: of conformity... - Page 10 SUZHOU TOLSEN TOOLS CO.,LTD. www.tolsentools.com TOLSEN is a trademark or registered trademark of TOLSEN TOOLS. All rights reserved. TolsenWorld SCAN TO VISIT MADE IN CHINA PRODUCT LINK...
Need help?
Do you have a question about the FORCE XPRESS 88551 and is the answer not in the manual?
Questions and answers