LPS PP Series Installation Instructions

5 YEARS LImITEd WARRANTY
The LPS® Surge Protective Devices (SPD)
manufactured by Lightning Protection
System Sdn. Bhd. meets the ISO 9001 Quality
Management System.
LPS® warrants to the original purchaser that the LPS® products shall be
free of defects in design, material and workmanship. LPS® will, at its
option, repair or replace, free of charge, any properly installed LPS® SPD
device that is damaged by lightning induced surge for a period of five
years. This warranty does not cover damage associated with improper
installation, sustained over voltage, vandalism, theft, normal wear and
tear, obsolescence, abuse, unauthorised modification or alteration,
misuse or catastrophic events. Except as expressly provided by this
warranty, LPS® disclaims liability for any incidental, indirect, special or
consequential damages arising out of the sale or use of any LPS® SPD
products (including without limitation lost business profits, loss of data
and all freight, mileage, travel time and insurance charges associated
with warranty coverage claims).
All claims must be made within thirty (30) days and warranty seals must
not be tampered.
Kindly take note that the customer has to send the 'damaged' LPS® SPD
back to our Marketing Office and to collect it at his own expense for
product warranty claims.
Lightning Protection System Sdn. Bhd. (362924-D)
No. 42-4, Jalan Kuchai Maju 10, Kuchai
Entrepreneurs' Park, 58200 Kuala Lumpur, Malaysia
T: +603–7980 5911 • F: + 603–7980 4862
E: info@lpsystem.com • www.lpsystem.com
PRODUCT
The LPS® PP Series are Surge Protective Device (SPD) for maximum 5 amps
DC Power Supply. The Standard Clamping voltage is 150 V for PP–2/110.
Installation procedures and safety precautions
1. Do not install during thunderstorm.
2. Turn off­ power supply to all equipment to be protected.
3. Verify that the equipment chassis is earthed.
4. Add a 2.5 mm
LPS® PP Series
INSTALLATION INSTRUCTIONS
TECHNICAL SUPPORT
T: +603–7980 5911
E: info@lpsystem.com
green ground wire to G of EQUIP terminal of SPD and
2
connect the other end (with cable lug) to the metal chassis of equipment
by:
w Removing a screw on the metal chassis that is within reach of the
ground wire.
w Removing any paint around the screw hole.
w Tighten screw with ground wire cable lug under it.
w If equipment has no metal chassis, connect the ground wire to the
nearest power socket earth / earthed metal equipment rack / earthed
metal bracket which support the equipment.