1. OUTLINE DinMeter is a1/32 DIN standard embedded development board equipped with a 1.14-inch ST7789 screen and powered by an M5StampS3 as its main controller. It features a built-in rotary encoder for precise knob position tracking. Additionally, it includes an RTC circuit, an onboard buzzer, and buttons below the screen for device interaction and alert notifications.
3. QUICK START 3.1. Print WiFi information 1. Open the Arduino IDE (refer to https://docs.m5stack.com/en/arduino/arduino_ide View the installation development board and software tutorial) 2. Select the M5StampS3 board and upload the code 3. The screen displays the scanned WiFi and the intensity...
Page 6
3. QUICK START 3.1. Print BLE information 1. Open the Arduino IDE (refer to https://docs.m5stack.com/en/arduino/arduino_ide View the installation development board and software tutorial) 2. Select the M5StampS3 board and upload the code 3. The screen displays the scanned BLE device...
FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Need help?
Do you have a question about the DinMeter and is the answer not in the manual?
Questions and answers