Table of Contents
Advertisement
To connect to the web-based Configuration Utility, enter the
S
2
TEP
router's default LAN IP address in the browser's Address bar:
http://192. 1 68. 1 . 1
A password request prompt appears.
Enter the following user name and password, and then click OK.
S
3
TEP
•
User name: admin
•
Password: admin
For added security, you should later set a new administrator
N
OTE
password by using the Administration > Management page in
the web-based Configuration Utility.
The web-based Configuration Utility appears, displaying the Basic
Setup page.
In the Internet Setup section, choose the Internet Connection
S
4
TEP
Type that was specified by your ISP:
•
Automatic Configuration - DHCP: This type of connection
allows your router to obtain an IP address dynamically from
your ISP's network.
•
Static IP: This type of connection requires that your ISP
assigned a fixed IP address to your account.
•
PPPoE: This type of connection requires a login for each
Internet connection.
•
PPTP: This type of connection is used in Europe only.
•
L2TP: This type of connection is used mostly in Europe.
•
Heart Beat Signal: This type of connection is used in Australia.
Enter the information that your ISP provided. The fields vary,
S
5
TEP
depending on the selected connection type.
•
IP Address, Subnet Mask, and Default Gateway: Enter the
information that the ISP provided for your fixed IP address.
•
Primary DNS and Secondary DNS: Enter the IP address of at
least one Domain Name System (DNS) server for your ISP.
Cisco Small Business WRV210 Quick Start Guide
7
Advertisement
Table of Contents
