HUAWEI HG231f Wireless-N Router
User Guide
5
5.1 Setting Up a Wireless Connection Through the
WPS
Button
The router supports the WPS function. If your network adapter also su
function, you can use the WPS function to set up a wireless connection between your PC
and the router quickly. To set up a wireless connection, do as follows:
Step 1
Set the WLAN parameters of router, and then set the Security Mode to WPA-PSK,
WPA2-PSK
"Configuration
The WPS function can be used only when the security mode of the WLAN is set to WPA-PSK,
WPA2-PSK, or WPA-PSK/WPA2-PSK.
Step 2
Press the WPS button of the router to enable the router to enter the WPS negotiation
state.
The WPS indicator
that the WPS function cannot be enabled. For the solutions to other WPS problems, see
chapter 8 "FAQs."
Step 3
Enable the WPS negotiation function of the wireless network adapter on your PC within
two minutes, and then wait for a moment (typically 10s and at most 120s).
The WPS indicator
router is
connected to your PC through the WLAN. This state lasts 300s. Then the WPS
indicator
turns off.
----End
After finishing the configuration, if the other PCs need to set a wireless connection through
the WPS button, please repeat Step 2 to Step 3.
5.2 Setting U
PIN M
ode
The router supports the AP PIN mode of the WPS function. If your network adapter also
supports the AP PIN mode o
Issue 01 (2010-04-01)
Configuration of WLAN Parameters
or WPA-PSK/WPA2-PSK as prompted. For details, see chapter 4
of Internet Access Parameters."
of the router blinks. If the WPS indicator does not blink, it indicates
of the router becomes on from the blinking state, indicating that the
p a Wireless Connection Through the AP
f the WPS function; you can use the AP PIN mode to set up
5 Configuration of WLAN Parameters
pports the WPS
5-1