Subscribe to Our Youtube Channel
Related Manuals for ORTEC Model 710
Summary of Contents for ORTEC Model 710
- Page 1 Model 710 Quad 1-kV Bias Supply Operating and Service Manual ® Printed in U.S.A. ORTEC Part No. 761850 1202 Manual Revision F...
-
Page 2: Warranty
In the event ORTEC fails to manufacture or deliver items called for in this agreement or purchase order, ORTEC’s exclusive liability and buyer’s exclusive remedy shall be release... -
Page 3: Table Of Contents
CONTENTS WARRANTY ............... ii SAFETY INSTRUCTIONS AND SYMBOLS . -
Page 4: Safety Instructions And Symbols
SAFETY INSTRUCTIONS AND SYMBOLS This manual contains up to three levels of safety instructions that must be observed in order to avoid personal injury and/or damage to equipment or other property. These are: DANGER Indicates a hazard that could result in death or serious bodily harm if the safety instruction is not observed. -
Page 5: Safety Warnings And Cleaning Instructions
SAFETY WARNINGS AND CLEANING INSTRUCTIONS DANGER Opening the cover of this instrument is likely to expose dangerous voltages. Disconnect the instrument from all voltage sources while it is being opened. WARNING Using this instrument in a manner not specified by the manufacturer may impair the protection provided by the instrument. - Page 6 Rear Panel...
-
Page 7: Description
Model 710, and to ensure 2. SPECIFICATIONS* The Model 710 contains four identical bias supplies with independently adjustable voltage and polarity. The specifications apply to each of the four channels unless noted otherwise. OUTPUT VOLTAGE RANGE Front-panel switch 2.1. -
Page 8: Controls And Indicators
VOLTAGE CONTROL RESOLUTION 0.5 V on POLARITY JUMPER (1 per channel) Internal, 1000 V range; 0.05 V on the 100 V range. printed circuit board jumper selects either positive or negative output polarity. OUTPUT VOLTAGE REGULATION <0.001% or POS/NEG LEDs (2 per channel) Front-panel, 1 mV (whichever is greater). -
Page 9: Outputs
Model 710. The temperature of equipment mounted on the rear panel of the Model 710. It is more in racks can easily exceed the maximum limit of convenient to make these connections before the 50°C unless precautions are taken. -
Page 10: Operation
Full-scale voltages of 100 or 1000 V can be selected. Each of the four channels can shown in Figure 4.2. The Model 710 is calibrated so also be disabled by this switch. that the dial reading or remote programming voltage should correspond to the output voltage. -
Page 11: Over-Current And Vacuum Shutdown
20 important parameter in both the depleted (sensitive) depth of the detector and the collecting field When NIM power is applied, the Model 710 turns On strength. in the over-current conditions. Thus, the supply must be reset for operation. -
Page 12: Maintenance
3. Connect ac power to the NIM-standard Bin. 11. Set the output voltage to zero and connect 4. Plug the Model 710 into the Bin and check for output 1 to the ac-coupled input of a 100-MHz proper mechanical alignment. -
Page 13: Repairs
Return Autorization Number can 5.3. REPAIRS be assigned to the unit. This number should be This instrument can be returned to the ORTEC marked on the address label and on the package to factory for service and repair at a nominal cost. Our... - Page 14 Coaxial *17 - 12 V Coaxial Spare bus Coaxial Reserved bus *41 117 V ac (neutral) Spare *42 High-quality ground Spare Ground guide pin Reserved Pins marked (*) are installed and wired in ORTEC’s 4001A and 4001C Modular System Bins.
Need help?
Do you have a question about the Model 710 and is the answer not in the manual?
Questions and answers