LG G3 LCD Replacement Manual

What's in the box

• LCD & Digitizer Assembly x1
• Repair Tool kit x1
• Tempered Glass Protector x1
  Official store: www.krnetshop.com
  CS Contact: info@krnetshop.com

Setting Up

1. Place the phone display down
   
2. Remove the back cover by using your fingernail or the opening tool pick (Red rectangle)
   
   There is a small gap. Need to be gentle and move it along the edge of the phone until the back cover pops off when using the tool pick or your fingernail.
   
3. Carefully remove sim-card and battery from the phone
   
4. Remove all 13 of the screws from the mid-frame
   
5. After the screws are removed, need to take away the bottom panel by gently lifting using the opening tool pick or your fingernail.
   
6. Do not pull up too forcefully, as there is a risk of the top panel breaking.
   
7. Use the flat part of the plastic opening tool to disconnect all four flex cable connectors from the motherboard.
   
   Need to be very gentle as the connectors are very easy to be torn or break
   
8. Remove the motherboard carefully from the phone
   Note:
   Please take extra care on the ribbon cables because if the other components are functional. Damaging them may result in other components not working
   
9. Remove headphone jack from bottom part of the phone
   
   Note:
   Need to pay extra attention on remove the port because it is struck with an adhesive, so need to be very careful to pry it off with the pick
   
10. Remove vibrator at the top left corner
    
11. Remove earpiece speaker at the top
    
12. Install the headphone jack, vibrator and earpiece speaker on new assembly
    
13. To reassemble your device, reverse from step 8