Advertisement
NOTE: A printed copy of this document may not be the latest revision. It is the responsibility of the user to ensure that
the latest revision is used. The latest revision of this document may be printed from the AeroLEDs electronic document
repository. Revision history follows on page 2
This document contains proprietary information of AeroLEDs. Neither receipt nor possession thereof confer any right to
reproduce or use, or disclose, in whole or in part, any such information without written permission from AeroLEDs.
Approval
Author
Check
Quality
Date:
Typed signatures indicate approval. Handwritten,
Status:
or electronic signature approval of this document
Release
is on file at AeroLEDs, Boise, Idaho.
0107-0004 SunSpot 46-4000 Series Installation Rev_J.docx Page 1 of 10
Installation Instructions
Sunspot 46-4000 series
AeroLEDs, LLC
8475 W. Elisa St.
Boise, ID, 83709
208-850-3294
Name
Jennifer Blanchfield
Nate Calvin
Mark McCormack
20 July 2023
Intent
Installation and Operation Instructions
for the Sunspot 46-4000 series lights
Document Number
0107-0004
Revision
J
Advertisement
Table of Contents
Related Manuals for AeroLEDs Sunspot 46-4000 Series
Summary of Contents for AeroLEDs Sunspot 46-4000 Series
- Page 1 NOTE: A printed copy of this document may not be the latest revision. It is the responsibility of the user to ensure that the latest revision is used. The latest revision of this document may be printed from the AeroLEDs electronic document repository.
-
Page 2: Revision Record
04/13/2020 J. Blanchfield All Pages Revised 05/07/2018 D. Wilkinson All Pages Revised 02/12/2018 D. Wilkinson 1 (limitations) 04/25/2017 D. Wilkinson All Pages Revised 09/12/2016 D. Wilkinson Initial Revision 08/30/2016 D. Wilkinson 0107-0004 SunSpot 46-4000 Series Installation Rev_J.docx Page 2 of 10... -
Page 3: Table Of Contents
TABLE OF CONTENTS System Description ............................... 4 Model Numbers ................................4 Airworthiness Limitations ............................5 Installation ..................................5 Wiring Diagrams ................................8 0107-0004 SunSpot 46-4000 Series Installation Rev_J.docx Page 3 of 10... -
Page 4: System Description
Switch Position Function Open Open Light OFF Open Closed Landing Pulse Landing Closed Open Light OFF Closed Closed Pulse Note: Refer to §5 Wiring Diagrams Table 2 Current consumption per input 0107-0004 SunSpot 46-4000 Series Installation Rev_J.docx Page 4 of 10... -
Page 5: Airworthiness Limitations
Table 4 Installation Consult 14CFR, §43.13-1B for guidance on acceptable methods, techniques, and practices. Mount in approved bulb holder. For retrofit installation existing circuit breaker or fuse may 0107-0004 SunSpot 46-4000 Series Installation Rev_J.docx Page 5 of 10... - Page 6 Installation Procedures Reference the airframe manufacturer’s maintenance manual to complete the following steps If the AeroLEDs light(s) chosen for installation are higher wattage than the light(s) being removed, ensure the Electrical Load is not appreciably affected and ensure that all circuit components (circuit breaker, wire, switches, relays, etc., as applicable) are appropriate for the...
- Page 7 Check for continuity in wiring and connections d. If wiring is verified, remove light and bench-check with appropriately sized power supply If above actions do not correct problem, contact AeroLEDs tech support at 1-208-850-3294 for a resolution. 0107-0004 SunSpot 46-4000 Series Installation Rev_J.docx Page 7 of 10...
-
Page 8: Wiring Diagrams
Wiring Diagram for Single Sunspot with Pulse SYMBOLS TERMINAL PWR BUS (V+) Y EL PULSE CAP & STOW MASTER SLAVE FUSE TERMINAL GND BUS SWITCH Notes 1) Screw terminals are not polarity sensitiv e Figure 5-2 0107-0004 SunSpot 46-4000 Series Installation Rev_J.docx Page 8 of 10... - Page 9 TERMINAL Notes 1) Screw terminals are not polarity sensitiv e Figure 5-3 If lights are installed in close proximity (within two feet), install using an AeroLEDs sync circuit • AeroLEDs part number 00-8120 • Installation Guide 0017-0002 0107-0004 SunSpot 46-4000 Series Installation Rev_J.docx Page 9 of 10...
- Page 10 CAP & STOW TERMINAL FUSE Y EL PULSE SWITCH MASTER SLAVE Notes TERMINAL 1) Screw terminals are not polarity sensitiv e TERMINAL Y EL PULSE MASTER SLAVE TERMINAL Figure 5-4 0107-0004 SunSpot 46-4000 Series Installation Rev_J.docx Page 10 of 10...
Need help?
Do you have a question about the Sunspot 46-4000 Series and is the answer not in the manual?
Questions and answers