MARKS USA IQ7 Installation Instructions

IQ7 - Rim Exit Device Lockset Installation Instructions
1
Exterior
For existing Exit Device installation:
Remove the current exit device and set aside. Mark the vertical and horizontal lines
of the inside spindle hole and outside lever hole. The marked lines are used to
correctly position the drilling templates.
NOTE: Drilling template is supplied with adapter plate.
For New Installation:
Mark a vertical and horizontal line of the inside spindle hole and outside lever hole.
3
After the lever is assembled, insert spindle spring assembly into rotating hub.
For alignment of spindle and hub, see below.
2
Interior
4
Page 1
365 Bayview Ave., Amityville, NY 11701
631-225-5400 • 1-800-526-0233 • Fax 631-225-6136 • www.marksusa.com
©
Install Lever:
1. Position lever on tube with correct handing, and fasten set screw using allen
wrench as shown above.
2. i-Que is self adjusting for 1-3/4" - 2" door thickness.
Pass the cable assembly with connectors through the 1" hole. Then place the
outside trim assembly on the door.