Page 1
WIRELESS AIR SPRING CONTROLS 10470 Kit w/ 12 VDC 325 Series Air Compressor Kit w/ 12 VDC 90 Series Air Compressor 10472 Kit w/ 12 VDC 425 Series Air Compressor 10477 Giving you the ability to adjust your air spring pressure from your phone with the touch of a button.
REQUIRED TOOLS • Wire Strippers Assembly, Wireless Compressor: • 325 Series Compressor (10470) HP10451 • Terminal Crimper • 90 Series Compressor (10472) HP10452 • Heat Gun or Torch • 425 Series Compressor (10477) HP10455 • Ratchet and Socket Set Harness, Single Channel Wireless HP10454 •...
Page 3
FROM ROAD SPRAY AND DEBRIS M8685 UNAUTHORIZED DISCLOSURE, USE OR MANUFACTURE IN WHOLE OR IN PART IS PROHIBITED ELECTRONIC DESIGN AND OTHER DISCLOSURES PROPERTY OF PACBRAKE CO. SURREY, B.C., CANADA SECURE RELAY WITH P60100 C241 SELF TAPPING SCREW OR TIE...
Page 4
THREAD FILTER INTO COMPRESSOR HAND TIGHT UNAUTHORIZED DISCLOSURE, USE OR MANUFACTURE IN WHOLE OR IN PART IS PROHIBITED ELECTRONIC DESIGN AND OTHER DISCLOSURES PROPERTY OF PACBRAKE CO. SURREY, B.C., CANADA SECURE RELAY WITH P60100 SELF TAPPING SCREW OR TIE KIT CONTENTS...
Page 5
THREAD FILTER INTO COMPRESSOR HAND TIGHT UNAUTHORIZED DISCLOSURE, USE OR MANUFACTURE IN WHOLE OR IN PART IS PROHIBITED ELECTRONIC DESIGN AND OTHER DISCLOSURES PROPERTY OF PACBRAKE CO. SURREY, B.C., CANADA SECURE RELAY WITH P60100 SELF TAPPING SCREW OR TIE KIT CONTENTS STRAPS 0 mm [240"]...
Single Channel Wireless Air Spring Controls L6557 BEFORE STARTING THE INSTALLATION: Read through this manual and ensure you can complete the installation once started. Ensure the kit you received contains all the items shown in the Kit Contents on Page 2. It is recommended to use a good quality anti-seize on all fasteners.
Single Channel Wireless Air Spring Controls L6557 MARK & DRILL MOUNTING HOLES Use the air compressor and controller as templates to mark the locations of the drilled holes. Place each component in the desired location/orientation and mark the centers of each hole: 4 holes on the compressor, 2 holes on the controller.
Page 8
Single Channel Wireless Air Spring Controls L6557 SECURE WIRING HARNESS RELAY Included in the wiring harness assembly is a built-in sealed relay which must be secured to prevent damage over time. When all harness connectors are attached to the compressor assembly and controller, secure the relay in the nearby area that leaves the harness unstrained.
Page 9
Single Channel Wireless Air Spring Controls L6557 HARNESS WIRING AND INSTALLATION Refer to the wiring schematic below (Figure 7) for making the required electrical connections: CONNECT THE HARNESS TO THE BATTERY: • Strip each wire end of the 30 Amp fuse holder, the end of the 10 AWG black wire, and the end of the 12 AWG red wire. •...
Page 10
Single Channel Wireless Air Spring Controls L6557 CONNECT THE HARNESS TO SWITCHED IGNITION POWER (CONTINUED) • Ensure the ignition is OFF before proceeding • Crimp the T-tap connector to the 12 VDC switched power line • Strip each end of the 15 Amp fuse holder and the end of the 16 AWG red wire •...
• Open the Wireless Air Spring Controls app. The Bluetooth toggle will illuminate to show that your device has successfully connected to the controller on the Wireless Controls kit. NOTE: If multiple Pacbrake app controlled devices are nearby, a window will be displayed to select a controller for connection.
Single Channel Wireless Air Spring Controls L6557 13 BLUETOOTH TOGGLE The Bluetooth Toggle illuminates when it has successfully connected to the wireless controller. Tap the Bluetooth toggle to manually connect or disconnect from the controller. NOTE: The app automatically connects to the controller on start-up. 14 PRESSURE INDICATOR The Pressure Indicator shows the pressure of each air spring with an accuracy of ±...
Page 13
Single Channel Wireless Air Spring Controls L6557 DISCLAIMER Driving while distracted can result in loss of vehicle control that may lead to an accident, severe personal injury, or death. The driver’s primary responsibility is in the safe and legal operation of a vehicle, and use of any handheld devices, other equipment, or vehicle systems which take the driver’s eyes, attention and focus away from the safe operation of a vehicle or which are not permissible by law should never be used during operation of the vehicle.
Need help?
Do you have a question about the 10472 and is the answer not in the manual?
Questions and answers