A CLOSER LOOK LED Indicator LED Indicator Touch Sensor Touch Sensor Charging Contacts Charging Contacts...
Page 4
CHARGING Charging the Earphones Place the earphones in the charging case in order to charge. Charging (Indicator is RED) Charging Complete (Indicator is OFF) Charging the Case Connect the included USB-C cable into the charging port on the case. Charging (Indicator is Blue & Flashing) Charging Complete (All 3 indicators are Solid Blue) Charging Time: Approximately 2-3 Hours...
POWERING ON/OFF When first using your earphones place them into the case. Remove them from the case and they will automatically turn on. Place them back into the case and they will automatically turn off. Press and hold the touch sensor on either earphone for 3 seconds to power on. Press and hold the touch sensor on either earphone for 4 seconds to power off.
Remove your earphones from the case and they will power on and go into pairing mode. AIWA Connect Pro Go to the Bluetooth settings menu on your phone. Make sure that Bluetooth is turned on. Connect to the device listed as “AIWA Connect Pro.”...
Page 7
USING YOUR EARPHONES LEFT EARPHONE Decrease Volume: Press Previous Track: Double Press Voice Assistant: Press and Hold for 2 Seconds Answer Call: Press End Call: Press and Hold for 2 Seconds Decline Call: Double Press Low Latency ON/Off: Triple Press RIGHT EARPHONE Increase Volume: Press Next Track: Double Press...
Page 8
Reset Go to the Bluetooth settings menu on your phone. Make sure that Bluetooth is turned off. Place the earphones in the charging case to turn them off. Take out one earphone from the charging case. The indicator light flashes red and blue alternately.
SAFETY PRECAUTIONS When using your earphones, basic safety precautions should always be followed including: 1. READ ALL INSTRUCTIONS BEFORE USING YOUR EARPHONES AND CHARGING CASE. 2. Do not use the product near water. Do not put on wet surfaces. 3. Only clean using a clean cloth. 4.
FCC STATEMENT Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
To Obtain Warranty Service and Troubleshooting Information: Call (877) 397-8200 or visit our website at www.aiwa.co. To receive Warranty service along with the name and address of an authorized product service center, the original consumer purchaser must contact us for problem determination and service procedures.
Need help?
Do you have a question about the Connect Pro and is the answer not in the manual?
Questions and answers