Related Manuals for Aiwa Prodigy Swim AI5006
Summary of Contents for Aiwa Prodigy Swim AI5006
- Page 1 Prodigy Swim Bone Conduction Wireless Headphones HOURS True 8 GB Built-In Up To 12 Hours IP68 Memory Card Waterproof Bone Conduction Playtime Drivers Per Charge User’s Manual Item: AI5006...
-
Page 2: What's Included
WHAT’S INCLUDED Prodigy Swim Bone Conduction Wireless Headphones Prodigy Swim Bone Conduction Wireless Headphones HOURS True 8 GB Built-In IP68 Up To 12 Hours Memory Card Waterproof Bone Conduction Playtime Drivers Per Charge Quick Start Guide Item: AI5006 Magnetic Sponge Earplugs User’s Manual Charging Cable... -
Page 3: A Closer Look
A CLOSER LOOK Magnetic Charging Port + Button - Button Power Button LED Indicator Light... -
Page 4: Magnetic Charging
MAGNETIC CHARGING Connect one end of the magnetic charging cable to the magnetic charging port on your headphones. When connected properly the cable snaps securely in place. Insert the other end into the a suitable USB charging adapter. (red) charging (blue) charging complete While charging, the LED indicator light turns red. -
Page 5: Powering On/Off
POWERING ON/OFF POWERING ON Press and hold the power button for approximately three seconds to turn ON (ON) the headphones. The indicator light will 3 SECONDS PRESS & HOLD POWERING OFF Press and hold the power switch for seconds to turn the headphones OFF. The (OFF) 5 SECONDS PRESS &... -
Page 6: Bluetooth Pairing
(Blue + Red Flashing) Once powered on, your headphones will go into pairing mode. The LED Indicator light AIWA Swim Go to the Bluetooth settings menu on your phone. Make sure that Bluetooth is turned on. Connect to the device listed as “AIWA Swim.”... -
Page 7: Using The Headphones
USING THE HEADPHONES Previous Song: Press and hold Button for 1.5 seconds. Next Song: Press and hold Button for 1.5 seconds. Press Button. Increase Volume: Decrease Volume: Press Button. Press Button. Play / Pause: Press and hold Button for 2 seconds. Voice Assistant: Answer: Press... -
Page 8: Memory Card Mode
MEMORY CARD MODE memory card. Uploading Music the steps below: 1. Connect one end of the magnetic charging cable to the magnetic charging port on your headphones. When connected properly the cable snaps securely in place. 2. Insert the other end into the an available USB port on your computer. -
Page 9: Safety Precautions
SAFETY PRECAUTIONS When using your headphones, basic safety precautions should always be followed including: 1. READ ALL INSTRUCTIONS BEFORE USING YOUR HEADPHONES. 2. Only clean using a clean, soft cloth. supervision is advised. 6. Do not expose this product to temperatures above 100°F. Keep out of direct sunlight. -
Page 10: Fcc Statement
FCC STATEMENT could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. -
Page 11: Warranty
To Obtain Warranty Service and Troubleshooting Information: Call 1-800-592-9541 or visit our website at www.aiwa.co. To receive Warranty service along with the name and address of an authorized product service center, the original consumer purchaser must contact us for problem determination and service procedures. - Page 12 AIWA Edison, NJ 08817 © 2024 Aiwa Acquisitions LLC. All rights reserved. AIWA and associated marks are owned by Aiwa Acquisitions and used under license. Keep all relevant information for future reference. The Bluetooth® word mark and logos are registered trademarks owned by the...
Need help?
Do you have a question about the Prodigy Swim AI5006 and is the answer not in the manual?
Questions and answers
how to par the swim head phones to my s24 altra samsung phone
@stan schuett it doesn't want to pair up
I have plugged in my device to charge after I thought I had charged it and upon using it I was made aware it had 10% power. I connected it to the charger and it has turned blue meaning it is charged but it is not. Should I just leave it on the charger? Any advice?