Hulkman Alpha 85S / 85 Manual

IN THE BOX

PRODUCT PARTS AND FUNCTIONS DESCRIPTION

1. Display Screen
2. 12V DC Output Port (OUT, MAXI 50W)
3. USB-A Output Port (OUT)
4. USB-C Input/Output Port (IN/OUT)

5. Power Button: Press for I -2s to power on the jump starter.
6. LED Button: Long press for 1-2s to power on the LED. Short press to switch the LED mode.
7. 12V Battery Clamps Output
8. LED

DISPLAY SCREEN DESCRIPTION

1. Battery Power Percentage
   (Charge/Standby, Discharge)
2. SC 65W Fast Charging
3. Charging
4. Discharging
5. Error Icon
6. "+" and "-" poles of battery clips reversed
7. Low-Temperature Heating (Alpha 85S Unique Function)
8. Ready To Start

JUMP STARTING THE CAR

1. Insert the jumper cable into the booster and connect the clamps to the car battery.
   
2. The screen displays 'Ready'.
   
3. Start the car engine.
   

ERROR MESSAGE/SPECIFIC OPERATION METHOD

ERROR CODE	PROBLEM	SOLUTION
	The jumper clamps are connected incorrectly.	Reverse them to ensure the correct connection
	The car battery is weak or nearly dead.	Activate the Force Start Function by pressing both the Power and LED buttons simultaneously for 2-3 seconds.
	The jump starter is inoperable due to extreme temperatures.	Wait for the jump starter to return to its optimal operating temperature range of 5°F to 113°F (-20°C to 45°.
	The Jump locked aker frequent starter is short-term use.	It will automatically unlock after 10 minutes.

If the problem persists, stop using the jump starter and contact the seller from where the product was purchased.

SPEED CHARGING THE ALPHA 85/ALPHA 85S

This product utilizes SC 65W's patented speed charging technology. Within 5 minutes of charging, it can start a car with 6.5L or less of gasoline. When the product is fully charged, it can start a car with up to 8.5L of gasoline.

PRE-HEATING TECHNOLOGY

Alpha 85S can be used at -40°C.The jump starter reaches starting temperature within 100 seconds. Without any operation, the jump starter will automatically tum on intelligent temperature control function according to the environment.

LED

THE LED HAS FIVE LIGHT MODES:

1. 50% Luminosity:
   Press the LED button for 1-2 seconds.
2. 100% Luminosity:
   Press the LED button again.
3. White Strobe Light:
   Press the LED button again.
4. White SOS Light:
   Press the LED button again.
5. Red Strobe Light:
   Press the LED button again.

SPECIFICATIONS

Applicable Equipment: 12V equipment battery
Maximum Peak Current: 2000A
Battery Capacity: 74Wh
USB-C Input: SC1.0 65W/PD18W (5V⎓3A/9V⎓2A/12V⎓1.5A)/5V⎓1A/5V⎓2A
USB-C Output: PD18W (5V⎓3A/9V⎓2A/12V⎓1.5A)/5V⎓1A/5V⎓2A
USB-A Output: QC3.0 18W (5V⎓3A/9V⎓2A/12V⎓1.5A)/5V⎓1A/5V⎓2A
DC Output: 15V⎓10A (Max 150W)

TOXIC AND HAZARDOUS SUBSTANCES OR ELEMENTS IN PRODUCTS

•: Indicates that free content of the hazardous substance in all homogeneous materials of the part is below the limit requirements specified in the 2002/95/EC (RoHS) standard.

FREQUENTLY ASKED QUESTIONS

1. Q: How to power off the device?
   A: The device has an intelligent detection function. Once there is no load or the device is fully charged, it will automatically sleep to save power to avoid loss.
2. Q: How long does it take to charge the Alpha 85/Alpha 85S?
   A: It takes approximately one hour to fully charge using the SC 65W wall charger.
3. Q: How long is the service life of the Alpha 85/Alpha 85S?
   A: The device has a service life of three to five years under normal use.
4. Q: How long can the Alpha 85 / Alpha 85S be stored when fully charged?
   A: The Alpha 85/Alpha 85S has a sophisticated circuit design. It can be stored for 18 months when fully charged and not in use. However, it is recommended to charge it every 3 months in order to extend the service life.

1. Read the user manual carefully before using this device.
2. Do not use this device as a car battery.
3. Do not use this device as a toy.
4. Pay attention when using this device near children to reduce the risk of injury.
5. The product is for 12V batteries only. It may be dangerous if it is used for batteries of other voltages.
6. Use the clamps delivered with the device. When the clamps or wires are damaged, stop using them immediately to avoid personal injuries such as fire or electric shock.
7. Do not allow positive and negative clamps to touch or connect to each other.
8. Ensure that there is no rust or foreign matter attached to the interface before start. Connect the device and clamps tightly to avoid affecting the starting performance of the product due to interface connection problems.
9. Remove the clamps from the car battery within 30 seconds after successfully starting the car. Otherwise, it may cause damage.
10. Do not start more than three times in a row. Otherwise, it will cause the product to overheat and damage the product. When you start multiple times, you should start two minutes apart.
11. Do not use clamps to power other devices.
12. Do not place the device in an environment where the temperature exceeds 60°C.
13. Charge the device at room temperature from 0° to 45°C.
14. Do not submerge in water or rain.
15. Do not put the device in extreme heat or fire.
16. Do not operate the device in an explosive environment, such as in the presence of flammable liquid, flammable gas, or dust.
17. Make sure that when using the device, someone is within a sufficient range that can hear you or within a sufficient distance to help you.
18. Before using the product, remove worm metal jewelry such as rings, bracelets, and necklaces.
19. Disconnect the jump starter and the clamp at the battery clamp plug to reduce the risk of damage to the power plug and power cord.
20. Do not use damaged or modified battery packs to avoid unpredictable consequences, leading to risks of fire, explosion, and injury.
21. Use the original charger or the same charger as the jump starter input terminal for charging.
22. Do not charge this device immediately after starting the car.
23. Do not start the car while charging the device.
24. The battery may leak in extreme cases. Do not directly touch the leaked liquid with your hands or skin. Rinse immediately with soap and water in case of contact. If the leaked liquid comes into contact with your eyes, rinse your eyes with cold water for at least 10 minutes and seek medical attention immediately.
25. Lithium battery products are handled according to local regulations at the end of product life.

This product is for 12-Voltage vehicle (equipment) batteries. It may be dangerous if used with other types of batteries. Read and understand the safety information before using the jump starter. Failure to follow the safety information may cause damage to the jump starter, and may also result in electric shock, explosions, fire, property damage, and personal injury.

CONTACTING HULKMAN

TEL: +1 (877) 892-9703
EMAIL: service@hulkman.com
ADDRESS: 99 South Almaden Blvd, STE 617, San Jose, CA 95113 USA