Advertisement
Quick Links
Rock-Steady Folding Table Saw Outfeed Kit Instructions
Effective October 2024
Review full instructions prior to use for important safety information.
Always check Rockler.com to confirm that you are using the most recent version of instructions for your product.
Advertisement
Related Manuals for Rockler Rock-Steady
Summary of Contents for Rockler Rock-Steady
- Page 1 Rock-Steady Folding Table Saw Outfeed Kit Instructions Effective October 2024 Review full instructions prior to use for important safety information. Always check Rockler.com to confirm that you are using the most recent version of instructions for your product.
-
Page 2: General Safety Warnings
This product is designed only for specific applications as defined in the instructions and should not be modified or used for any manner not described in these instructions. Use only recommended accessories. Before using the Rock-Steady Folding Table Saw Outfeed Kit: READ, UNDERSTAND and FOLLOW ALL INSTRUCTIONS AND SAFETY WARNINGS. KEEP THESE INSTRUCTIONS READILY AVAILABLE FOR FUTURE REFERENCE. - Page 3 PRODUCT SPECIFIC SAFETY WARNINGS > Minimum tabletop thickness: 3/4" > Any table created with the Folding Table Saw Outfeed Kit is NOT intended to serve as a full-fledged workbench – > Maximum tabletop thickness: 1 ⁄ ", depending on your saw only as a table to support material being cut on the table saw.
-
Page 4: Parts List
PARTS LIST Quantity Quantity Saw Bracket 10 5/16"-18 x 3/4" Carriage Bolt 3/8" Hole Insert 11 5/16" Flat Washer 1/4" Hole Insert 12 5/16"-18 Nylon Locknut 5/16"-8mm Hole Insert 13 3/8"-24 x 2" Hex Bolt (Fine Adjustment) 9mm Hole Insert 14 3/8"-24 Jam Nut Slotted Bracket 15 Crossbar... - Page 5 Fig. 2 Fig. 3 4. Hold the Saw Bracket (1) up to the saw’s rear rail, aligning the holes. Insert the correct Hole Insert (2, 3, 4 or 5) in the Saw Bracket, and then feed the mounting bolt from your saw through the hole.
- Page 6 The depth must not exceed 36". Making the Tabletop • The Rock-Steady Folding Table Saw Outfeed Kit is designed so the table can be folded down and stored on the saw. To minimize the chance of injury, the tabletop needs to be of a size and weight that you can maneuver without difficulty.
- Page 7 Fig. 7 3. Remove the outfeed top from the frame. Drill stopped 1/8" Leave a gap between the diameter pilot holes on the underside of the top at the tabletop and the saw locations you just marked, taking care not to drill all the way through the top.
- Page 8 3. Carefully allow the outfeed top to swing slowly downward to the lowered position. Check Rockler.com for updates. If you have further questions, please contact our Technical Support Department at 1-800-260-9663 or support@rockler.com 79721 Distributed by Rockler Companies, Inc.
Need help?
Do you have a question about the Rock-Steady and is the answer not in the manual?
Questions and answers