Advertisement
Advertisement
Table of Contents
Related Manuals for MDD LOCKER PLUS
Summary of Contents for MDD LOCKER PLUS
- Page 1 LOCKER PLUS locker-type cabinet...
- Page 4 Instruction manual – locks for Locker cabinets Reset 1 Electronic card lock ..................Electronic code lock ..................Combination lock ..................Ver. 1.6...
-
Page 5: Body Dimensions
Electronic card lock 1. 1. Body dimensions Lock Rod A Rod B 38,2 21,5 Assembly dimensions Lock Reset 1... -
Page 6: Programming The Lock
Rod A Rod B 27 mm 21,5 Specifications Number of modes: 3 Modes: private / public / office Master Key: yes (card) Position: vertical / horizontal Power supply: 4 AAA 1.5V batteries Application Wood: maximum 38 mm Glass: maximum 38 mm 3. - Page 7 Please note Note 1: The Manager Card acquires its status after it has been programmed. Before the programming, the card does not contain any data. Note 2: Without the Manager Card programmed, no further steps can be taken. Note 3: Describe or mark the Manager Card and keep it out of reach of third parties.
-
Page 8: Restore Factory Settings
Step 4. Programming the selected mode The mode is selected by performing the programming procedure several times. Which mode has been set is indicated by the number of beeps at the end of the procedure. Public • Press the Set button on the back of the lock 3 times. •... - Page 9 Electronic code lock 1. Body dimensions 16,2 2. Assembly Specifications Power supply: 3V CR2032 Application Wood: maximum 38 mm Glass: maximum 38 mm...
- Page 10 Electronic code lock 3. Usage / settings Opening Before activating the lock: Open the flap on the back of the lock, Insert a 3V Cr2032 battery into the lock, Close the flap. Opening: Enter the default code (1234) and press the OK button. You will hear a long beep.
-
Page 11: Troubleshooting
4. Turning off the public mode Enter the code and press OK, you will hear a long beep. Press and hold the OK button for about 2 seconds, when the LED starts flashing, press OK again. Enter the "43" code and press OK. You will hear a long beep indicating, that the public mode has been turned off. -
Page 12: Combination Lock
Combination lock 1. Body dimensions 25,3 73,4 1. PERSONAL 2. PUBLIC 3. CODE RESET Closed position Changing the mode 1. PERSONAL 2. PUBLIC 3. CODE RESET Modes of operation Open position Private mode Public mode 2. Usage / settings Programming 1. - Page 13 Turn the knob by 180 degrees - the pointer will be in the “open” position. Set your code and keep it out of reach of third parties. Turn the knob by 180 degrees - the pointer will be in the “close” position. Set the back switch position to “Personal”.
- Page 14 Code recovery in private mode: Please note If you need to open the lock in an emergency, use the corresponding Master Key. This key does not open the lock, it only allows you to find the forgotten code combination. Insert the key into the cylinder and turn it 180 degrees. Leave the key in this position until you have completed the next step.
- Page 15 Changing the mode from private to public: Enter your existing code. Set the back switch position to ,”Public code reset”. 1. PERSONAL 2. PUBLIC 3. CODE RESET Turn the knob by 180 degrees - the pointer will be in the “open” position. Set your code and keep it out of reach of third parties.
Need help?
Do you have a question about the LOCKER PLUS and is the answer not in the manual?
Questions and answers