Table of Contents
Advertisement
Quick Links
SECURITY SYSTEM ONLY
REMOTE CAR STARTER ONLY
SECURITY SYSTEM AND REMOTE CAR STARTER
AUTOMATIC / MANUAL TRANSMISSION - 1-WAY REMOTES
ORBITF2400
MODEL : OBTRF2400
FCC ID : 2ACKU-R2W02FM
IC : 12084A-R2W02FM
Manufacture :
FORTIN ELECTRONIC SYSTEMS
DESIGNED & ENGINEERED IN CANADA
DOC#: 25831 - REV:G 20170329 © 2016 ALL RIGHTS RESERVED
Model : ANT-FMH-2W
FCC ID : 2ACKU-A2W01FM
IC : 12084A-A2W01FM
Manufacture :
FORTIN ELECTRONIC SYSTEMS
User Guide
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Orbit ANT-FMH-2W
Summary of Contents for Orbit ANT-FMH-2W
- Page 1 REMOTE CAR STARTER ONLY SECURITY SYSTEM AND REMOTE CAR STARTER AUTOMATIC / MANUAL TRANSMISSION - 1-WAY REMOTES ORBITF2400 User Guide MODEL : OBTRF2400 Model : ANT-FMH-2W FCC ID : 2ACKU-R2W02FM FCC ID : 2ACKU-A2W01FM IC : 12084A-R2W02FM IC : 12084A-A2W01FM Manufacture :...
-
Page 2: Table Of Contents
TABLE DES MATIÈRES TABLE OF CONTENTS TABLE OF CONTENTS ......................... 2 INTRODUCTION ..........................2 CAUTION - WARNING ......................... 3 NOTE ..............................3 INDUSTRY CANADA USER NOTICE ...................... 3 GOVERNMENT REGULATIONS ......................3 USING THE REMOTE CONTROL ......................4 REMOTE-STARTING ..........................4 REMOTE-STARTING THE VEHICLE ....................... -
Page 3: Caution - Warning
CAUTION - WARNING IT IS THE RESPONSIBILITY OF THE REMOTE CAR STARTER OPERATOR TO: • ensure that the vehicle is parked in a safe and responsible manner. • ensure that the vehicle is not remotely started indoors (garage, underground park- ing). -
Page 4: Using The Remote Control
USING THE REMOTE CONTROL The remote starter is equipped with two 1-way 4-button multi-channel remote control . TIME COMMAND DESCRIPTION PRESSED Locks all doors, arm the anti-theft system and activates the Alarm (if LOCK 0,5 SEC. installed). Press LOCK for 3 sec- onds to activate the Panic Mode Unlocks all doors, disarms the anti-theft system and deactivates... -
Page 5: Accessory Preset
Approximately 5 seconds later the engine will crank. Once the vehicle starts STEP the parking lights will turn on and remain on for the entire duration of the Remote-Starter runtime, or until the Remote-Starter is shut down. If the vehicle fails to start on the fi rst attempt, the Remote-Starter will wait 3 seconds before it will attempt to start the vehicle again. -
Page 6: Driving Off
STEP 5 Remove the key from the ignition barrel. The vehicle will remain running with the Remote-Starter. STEP 6 Exit the vehicle and close all of the doors. The Remote-Starter will stop running once all the doors are closed. METHOD 2 This method must be programmed by the installer during installation. THIS METHOD WILL ACTI- VATE THE REMOTE STARTER SEQUENCE EVERYTIME THE END USER IS LEAVING THE VEHICLE. -
Page 7: Idle Mode (Manual Transmission)
to reset this timer. To activate Idle Mode (automatic transmission) proceed with the following steps: STEP 1 With the key in the barrel at the ignition (ON/RUN) position and the en- gine running, press the START button until the parking lights turn on. STEP 2 Turn the key to the OFF position and remove the key from the ignition barrel. -
Page 8: Turbo Mode (Manual Transmission)
STEP 1 With the engine already running, press the remote START button until the parking lights come on. STEP 2 Remove the key from the ignition barrel. The vehicle will continue to run with the the Remote-Starter. STEP 3 Exit the vehicle and close all of the doors. The vehicle will continue to run after all the doors are closed. -
Page 9: Valet Mode (Via Remote)
STEP 3 Press and hold the valet button once for 3 seconds to fi nish the sequence. STEP 4 Valet mode enabled:The LED is ON Valet mode disabled: The LED is OFF Note: The coded valet option allows a selection of one of the fi ve available codes. Once the installer chooses one of the codes, note the value here so you do not forget it_____________________. -
Page 10: Auxiliary Use
To disable Cold Start Timer Mode do any of the following: • Press and release the FUNCTION but- • Put the Remote-Starter/ • Turn the key to the ignition ton, within 12 seconds to simultane- alarm into Valet Mode. (ON / RUN) position. •... -
Page 11: Remote Door Locks
REMOTE DOOR LOCKS If the Remote-Starter is installed with door locks, you will be able to lock and unlock the vehicle without using the key or OEM key fob. To UNLOCK the doors and DISARM the Alarm: The parking lights will fl ash twice and the LED will turn OFF to confi rm the signal. -
Page 12: Alarm
ALARM AUDIBLE CONFIRMATION By default the Alarm will not send an audible confi rmation (horn/siren) after the fi rst signal has been received from the remote transmitter(s). SILENT : Press the LOCK or UNLOCK button ONCE and the park lights will fl ash, but the horn/siren will NOT confi rm the signal. -
Page 13: Transmitter Range
TRANSMITTER RANGE Several factors may affect the operating range of the remote transmitter: • A weak transmitter battery. • The operating environment such as in the city and airports due to radio interference, cell phone towers, etc… • Several types of metal such as the vehicle itself, other vehicles, the windshields tint lines and large build- ings. -
Page 14: Manufacturer Warranty
MANUFACTURER WARRANTY REMOTE STARTERS: Fortin Electronics Systems, hereinafter «the Manufacturer» warrants that the remote start mo- dule (control box), hereinafter « theModule» will be free from defects in thedesign or manufacture. The warranty is for the exclusive benefi t of the original consumer who purchases a Module from an authorized dealer and who installs the Module on a vehicle in his possession. - Page 15 Page 15 / 16...
- Page 16 USER GUIDE Page 16 / 16...
Need help?
Do you have a question about the ANT-FMH-2W and is the answer not in the manual?
Questions and answers