Download Print this page

No-Mar Classic HD Assembly Instructions Packet

Motorcycle tire changer

Download this manual

Assembly Instructions Packet

Motorcycle Tire Changer

For our latest instructional videos, visit:

5/32" Hex (Allen) Wrench - Included in Lube Box inside of Box A



3/16" Hex (Allen) Wrench - Included inside of Box B



3/4" (or 19mm) Wrench - Socket w/Ratchet, Combination or similar



7/16" (or 11mm) Wrench - Socket w/Ratchet, Combination or similar



For mounting your Tire Changer to the floor, we recommend using 1/2" x 3+1/2" (or 12mm x 100mm)

Concrete Wedge anchors (Power-Stud+® SD1 or similar) drilled to a minimum depth of 2+3/4" (or 70mm)

and installed per manufacturer directions with nuts and washers.

Classic® HD

NoMarTireChanger.com

(or scan the QR code below)

Tools Required for Assembly:

Need help?

Do you have a question about the Classic HD and is the answer not in the manual?

Page 1 Assembly Instructions Packet Classic® HD Motorcycle Tire Changer For our latest instructional videos, visit: NoMarTireChanger.com (or scan the QR code below) Tools Required for Assembly: 5/32" Hex (Allen) Wrench - Included in Lube Box inside of Box A  3/16" Hex (Allen) Wrench - Included inside of Box B ...
Page 2 Classic® HD Tire Changer Assembly Preparation & Master Parts List  A Box  Mount Demount Bar  C Box  MD Bar Handle  (2) Front Frame Arms  Spare Demount Tip  Rear Frame Arm  Lube Pint ...
Page 3 If you require further assistance or technical support, please call us at 888-98-NOMAR (888-986-6627) and we will be happy to assist you! Classic® HD Tire Changer Assembly Instructions Step 1: Remove all items from the A Box. Using the provided 5/32” Hex Wrench attach the MD Bar Handle to the MD Bar where the Install Handle sticker is located.
Page 4 Step 6: Install the Aluminum T hardware by inserting the Carriage Bolt into the side with the square notch, placing the washer over the other end of the Carriage Bolt, and then installing the Female T Knob to the end of the bolt. (Finger Tight, DO NOT OVER TIGHTEN YOU WILL STRIP THE BRASS THREADS) Step 7: Remove the ¾”...