Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Graco 24K206
Summary of Contents for Graco 24K206
- Page 1 Instructions Nip Sensor Kit 3A1901B For maintaining fluid supply levels. For professional use only. Part No. 24K206 Important Safety Instructions Read all warnings and instructions in HFR manual 313997. Save all instructions. TI17522a...
-
Page 2: Table Of Contents
Graco Standard Warranty ....6 Graco Information ......6... -
Page 3: Installation
Installation Installation 1. Follow the Shutdown procedure in the HFR manual. 4. Connect the nip sensor cable to the connector labeled “2B” located on the Motor Control 2. Remove the cover from the hydraulic power pack. Module (MCM). Keep all fasteners and cover for later installation. Connector TI17524a 5. -
Page 4: Setup
Setup Setup NOTE: See HFR manual for more detailed instructions NOTE: The fluid level is recommended to be 3-6 mm while performing steps 1-5, 9a, and 10c. (0.125-0.25 in.) from the sensor face after the HFR dis penses. NOTE: The LED on the sensor will be on when fluid level is within 12 mm (0.47 in.) from the sensor face. -
Page 5: Maintenance
Maintenance Maintenance NOTICE To avoid damage to the nip sensor, use a solvent compatible with plastic. Contact fluid supplier for recommended solvents. Inspect the nip sensor face daily for contaminants. Remove any contaminants found on the nip sensor face with sol vent. -
Page 6: Graco Standard Warranty
With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.
Need help?
Do you have a question about the 24K206 and is the answer not in the manual?
Questions and answers