Advertisement
Quick Links
• MP 350 Ultra
• MP 350 V.V. Ultra
• MP 450 Ultra
• MP 450 V.V. Ultra
• MP 550 Ultra
• MP 600 Ultra
• MP 800 Turbo
• MP 350 Combi Ultra
• MP 450 Combi Ultra
• MP 450 FW Ultra
• MP 450 FW XL Ultra
• MP 350 Ultra TP
• MP 800 Turbo TP
MP 350
MP 450
MP 550
MP 600
MP 800
MP 350
MP 800
MP 350
MP 450
MP 450
MP 450
Ultra
Ultra
Ultra
Ultra
Turbo
Ultra TP
Turbo TP
Combi Ultra
Combi Ultra
FW Ultra
FW XL Ultra
TRANSLATION OF ORIGINAL INSTRUCTIONS
09/01/2024
Advertisement
Related Manuals for Robot Coupe MP 350 Ultra
Summary of Contents for Robot Coupe MP 350 Ultra
- Page 1 • MP 800 Turbo • MP 350 Combi Ultra • MP 450 Combi Ultra • MP 450 FW Ultra • MP 450 FW XL Ultra • MP 350 Ultra TP • MP 800 Turbo TP MP 350 MP 450 MP 550...
- Page 2 www.robot-coupe.com Register your product on line...
- Page 3 UKCA Declaration of Conformity Robot-Coupe ® SNC declares that all the machines subject of - EN 60529 Degrees of protection provided by enclosures (IP Code): these original instructions, as well as their accessories and their • Requirements according to EN 60204-1. Minimum IP34 for packaging, comply with: control system enclosures, •...
- Page 4 SUMMARY WARRANTY CLEANING Motor unit • IMPORTANT WARNING After each use • INTRODUCTION TO YOUR Blades • NEW POWER MIXER Whisk holder • Whisks • SWITCHING ON THE APPLIANCE Mixing tool housing • Advice on electrical connections • Mixing tool •...
- Page 5 ROBOT-COUPE ., LIMITED WARRANTY Labour to sharpen and/or replacements for Shipping damages. Visible and latent Your new ROBOT-COUPE appliance defects are the responsibility of the freight blades which have become blunt, chipped or is warranted to the original buyer for carrier.
- Page 6 • However, for mixers of Special for tilting pan range • We recommend that you install your appliance on its • Never immerse the motor unit in water. (MP 350 Ultra TP, MP 800 Turbo TP), the protective wall frame. • For parts made from aluminum, use cleaning fluids ring attached to the end of the bell can be in contact intended for aluminum.
- Page 7 230 V / 50 Hz for power supplies of: MP 350 Ultra We therefore strongly advise you to read these 220 V to 240 V. MP 350 Ultra TP 50-100 instructions carefully before using the appliance. 120 V / 60 Hz.
- Page 8 However, for mixers of Special for tilting pan range preparation. (MP 350 Ultra TP, MP 800 Turbo TP), the protective Follow steps 1 to 6 above, then: • POWER CORD ring attached to the end of the bell can be in contact 7.
- Page 9 If using a support on top • WHISK FUNCTION power mixer on its pan support of the pan, ensure that the For greater efficiency, it is power mixer is positioned r e c o m m e n d e d h o l d i n g t h e in the centre of the support, appliance by the handle and the that it is at a slight angle,...
- Page 10 - Check that the machine is not plugged in. Removing the blade - Turn the bell in the direction of arrow 1 (see next figure) to separate the bell lug E from the tube lug F. blade locking Remove the bell. turn to attach bell Attaching the tube to the motor unit...
- Page 11 • MIXING TOOL FUNCTION (MP 450 FW XL Ultra) Optional extra with the MP 350 Combi Ultra and MP 450 Combi Ultra models. Attaching the mixing tool to the mixing tool housing: mixing tool housing mixing tool Line the flat side of the mixing tool B up with the flat Removing the casing Removing the whisks from the whisk holder side of the housing A.
- Page 12 USES & CLEANING PAN SUPPORT EXAMPLES W A R N I N G They enable the user to tilt the power mixer without any effort or else to leave it running on its own. All The mixer function makes it possible to carry out all As a precaution, always unplug your appliance stainless steel and completely dismantled, they are types of processing in the minimum of time, while...
- Page 13 • MIXING TOOL HOUSING • WHISKS W A R N I N G The success of your preparation will depend Never immerse the mixing tool housing The inside of the bell must not contain any in water or put it in the dishwasher. essentially on the state of the metal wires and liquid or food matter besides condensation.
- Page 14 Make sure the plug is pushed in far enough (two stages). If it is not, the control buttons will not work. After the cord has been MP 350 Ultra TP connected to the handle and plugged into the mains, a...
- Page 15 220 V / 60 Hz 1,500 to 9,000 250 to 1,500 • ELECTRICAL DATA Single-phase machine Single-phase machine MP 550 Ultra Single-phase machine MP 450 Combi Ultra MP 350 Ultra, MP 350 Ultra TP Speed Intensity Mixer Speed Whisk Speed Intensity Motor...
- Page 16 When using mixers in the Special bratt tilting - Power cord safety the motor will stop shortly. pan Range (MP 350 Ultra TP, MP 800 Turbo • Safety control button This stop indicates that the TP), we recommend pressing the appliance...
- Page 17 PROBLEMS • If the green voltage indicator light is off, check: - The network voltage light At first, try to identify precisely what has caused the - Correct connection of the mp 600 mp 800 power mixer to stop. cable to the wall plug. - Correct attachment of the •...
- Page 18 ELECTRICAL AND WIRING DIAGRAMS 09/01/2024...
- Page 19 09/01/2024...
- Page 20 09/01/2024...
- Page 21 Register your product on line Head Office, French, Robot Coupe Robot-Coupe Export and Marketing Department: Australia Pty Ltd: U.K. LTD: 48, rue des Vignerons Unit 3/43 Herbert St Fleming Way, Isleworth, 94300 Vincennes - France Artarmon NSW 2064 Australia Middlesex TW7 6EU Tel.: 01 43 98 88 15...
Need help?
Do you have a question about the MP 350 Ultra and is the answer not in the manual?
Questions and answers