Instar Plug & Play User Manual

Attach the wifi antenna to the cameras antenna
connector as shown above (User Manual Chapter
3 #11).
Press the cameras reset button for 3 seconds to
activate the cameras WPS service (User Manual
Chapter 3 #13). Wait for max. 5min for the camera
to connect to your Wifi network. If you press it for
10s, the camera will be reset to it's factory defaults!
The QR code contains all the necessary information
to add your camera. Please be aware that the
default login credentials will be used. If you want to
change the default password please check the
Quick Installation Guide. The password can only
be changed in the web user interface.
Plug in the power supply (User Manual
Chapter 3 #12) to start the camera.
Start our Android or IPhone app Instar
Vision. Choose to add a new p2p camera
and start the QR code scanner. Your QR code
is located on a lable on the camera case (s.
above).
The app will now connect to your cameras
live stream and you will be able to pan & tilt
the device, as well as to activate the audio
stream of the internal microphone and to
take snapshots.
=
Plug & Play
If your router supports the WPS (Wireless
Protected Setup) function, please press the
WPS button on the router, which looks
similar to the example above.
Scan the code to add your IN-6012 as a new
p2p camera and confirm the settings. If you
already changed the camera's admin login,
please adjust this in the following dialogue
as well.
The wps / p2p method allows you to quickly
connect your camera and check the
cameras live stream. Please refer to the
Quick Installation Guide for instruction on
how to access additional camera features.