Technical Support - Mackie D.2 - FIREWIRE CARD Instalation Instructions

5. The installer will display a screen with information
on the installation and prompt you to continue. Click
NEXT to begin installing the driver package.
6. You should see a small
window indicating that
the installer is running:
7. If you are prompted with an impertinent message
that the driver software has not passed Windows Logo
Testing, click CONTINUE ANYWAY.
8. Once the installer has prepared the system, you will
be prompted with a window to "connect devices and
turn them on." NOW you can connect your DJ Mixer
FireWire card to your PC using a FireWire cable. Once
you have done this, click NEXT.
9. Windows should
indicate that
it has detected
the Mackie DJ
FireWire option
card.
10. You may be prompted again by Windows to confi rm
the installation of driver fi les for the WDM portion of
the audio driver. Click CONTINUE ANYWAY to com-
plete the installation.
11. Windows
should indi-
cate that it
has detected
the WDM
audio driver for the Mackie DJ Mixer FireWire card.
12. The installer will display a window confi rming suc-
cessful completion of the installation procedures.
Click EXIT to complete the installation and exit the
installer.
13. You will be prompted to re-start your computer to
allow the changes to take effect. Re-start your PC to
enjoy the fruits of your labor.
Control Panel Details
The CD which came with your FireWire card contains in-
formation regarding the PC control panel for the d.2 FireWire
card. This allows you to adjust some advanced settings and the
sample rate for some Windows applications. Note: The maxi-
mum recording sample rate is 96 kHz. If the sample rate is set
to 176.4 or 192 kHz, you can playback, but not record.
Disclaimer
While every attempt has been made to make sure the infor-
mation on this instruction sheet is correct, there is always a
chance that things may change. Please check out our website
regularly, just in case updated instructions and PC drivers are
available: www.mackie.com

Technical Support

If you have any questions about your d.2 FireWire card,
please call Tech Support at 1-800-898-3211, 7 am to 5 pm PST.
Service and repair details for the FireWire card are the same
as explained in the d.2 owner's manual on page 18 and 19.
Mackie d.2 FireWire card installation, page 3 of 4