Mackie D.2 - FIREWIRE CARD Instalation Instructions page 2

3. Gently remove the FireWire card from its protective
bag.
Important! Do not touch the pins on the rear connec-
tor, or touch any of the exposed d.2 circuit boards or
components. This is in order to prevent damage due
to electrostatic discharge (ESD).
4. Inside the d.2, gently pull out the loose ribbon cable
and connector, just enough to connect it securely to
the rear connector on the end of the FireWire card.
5. Fit the card in place, with its large plate fl ush with
the bottom panel, and its FireWire connectors lined
up in the holes of the d.2 rear panel. Secure the bot-
tom plate in place using the four screws you took out
in step 2. Fit one other screw in the hole between the
two FireWire connectors. There will be one screw left
over to put under your bed.
MAIN OUT BOOTH
SEND
L R L L
LINE
MIC
LIVE
RECORD
RETURN
R L
~100-240 VAC 50-60Hz 20W
ON L
SERIAL / DATE CODE
R
6. Plug in the power cord and verify that the d.2 is still
working correctly. This completes the mechanical
installation, now its time for fun with computers.
Mac Installation
Connect a FireWire cable between the d.2 FireWire card and
your Mac computer, and it will recognize the card as a valid
audio device. Install Tracktion and have super fun and larks,
or use your favorite compatible playback and/or recording soft-
ware.
DESIGNED BY MACKOIDS IN WOODINVILLE, WA, USA • MANUFACTURED IN CHINA
FABRIQUE EN CHINE • COPYRIGHT ©2005 • "MACKIE", AND THE RUNNING MAN
FIGURE ARE TRADEMARKS OF LOUD TECHNOLOGIES, INC. • PATENT PENDING.
FX PGM 2 PGM 1 MIC
PHONO CD PHONO CD
R L L L L
R R R R
R
LINE GND LINE GND
PHONO PHONO
FIREWIRE
24-BIT/96kHz FIREWIRE I/O
OPTION CARD
DESIGNED BY MACKOIDS IN WOODINVILLE, WA, USA •
MANUFACTURED IN CHINA • FABRIQUE EN CHINE
COPYRIGHT ©2005 • "MACKIE", AND THE RUNNING MAN
FIGURE ARE TRADEMARKS OF LOUD TECHNOLOGIES, INC.
Windows XP Driver Install
Do NOT connect a FireWire cable between the Mackie d.2
FireWire card and your PC just yet. This will come later.
1. Insert the CD-ROM supplied with your FireWire card
into your PC's CD drive.
2. Double-click on "Setup Mackie DJ Mixer WinXP.exe"
in the root directory to run a self-extractor utility.
3. After extraction, a welcome page will appear automat-
ically. Smile, wave politely, say hello, and click NEXT.
4. The next screen will prompt you to choose the folder
into which the driver and control panel fi les will be
installed. We recommend that you select the default
installation folder for the driver fi les. Click NEXT
when you are ready to continue.
Mackie d.2 FireWire card installation, page 2 of 4
continued...