SkyLink KN-103 User Manual

Congratulations on your purchase of the Skylink® Wireless keypad Model KN-103. The Model
KN-103 works with the Skylink® receivers. In this package, you will find a wireless keypad with
1.5V AAA battery and screws.
The keypad transmitter can operate up to 4 receiver units, that also means one keypad
transmitter can operate up to 4 garage door openers.
Same PIN will be used for all doors. The factory default password is [0 0 0 0].
To operate door 1, you will enter [0 0 0 0][#][1]
To operate door 2, you will enter [0 0 0 0][#][2]
To operate door 3, you will enter [0 0 0 0][#][3]
To operate door 4, you will enter [0 0 0 0][#][4]
To program the keypad transmitter into the receiver, you must decide which door you need to
operate. If you only have one receiver, we suggest you to use door 1. i.e. [0 0 0 0][#][1]. Follow
the instructions below to program the keypad transmitter.
Follow the instructions below to change the PIN.
To change your PIN:
1. Enter the current PIN, (factory default PIN 0 0 0 0), press * .
2. Enter new 4 to 6 digit PIN, press * .
3. Enter new PIN again, press * .
For example, if you are changing the PIN number from 0000 to 123456, enter the following
sequence, 0000, *, 123456, * , 123456, * . If confirmed, the balcklit LED flashes and the unit emits
a long beep.
One 1.5 volt AAA type battery (included).
It is time to change the battery when the backlight no longer appears.
The Wireless kepad is approved by the FCC and it complies with
FCC
This device complies with Part 15 of the FCC Rules
Operation is subject to the following two conditions:
(1) this device may not cause
(2) this device must accept any interference received, including
interference that may cause undesired operation.
User Manual
MODEL KN -103
Brand name:Skylink
FCC ID:KUTKN103
IC:4454A-KN103
.
harmful interference, and