Magellan Outdoors Bryce Canyon Assembly Instructions

IMPORTANT: We advise you to assemble the tent once before going
camping to become familiar with the assembly. It is recommended that
two people be involved in the setup.
NOTE: To prolong the life of the tent floor, select a level, clean area for
the campsite. To prevent damage to the zipper, unzip the doors, prior to
tent setup, to allow air to enter the tent. To improve the weather resist-
ance of your tent, it is advisable to use seam sealer to coat all the exposed
seams. You should apply only to the underside of the fly and inside seams
of the tent. If applied to the outside of seams, discoloration of your tent
may occur.
STEP 1: Spread the tent out flat, floor side down.
STEP 2: Extend all the steel frame sections and fiberglas frame sections
by pulling out each section and placing it into the connected chain-
corded and shock-corded sections. Sort poles according to the parts
diagram list. Make sure to assemble the center leg poles(C+D).
STEP 3: Stake down the front base of the tent by inserting a stake
through the stake loops, located on either side of the door, and drive
the stakes into the ground at a 45° angle using a hammer or mallet.
Make certain the front of the dome tent is pulled out evenly and tight.
STEP 4: Locate the steel main roof pole(A) and slide it through the
middle pole sleeve and webbing loops. Locate the fiberglass side roof
poles(B), and slide them through the side pole sleeves. Make sure to
connect the corner plastic molds(F) to the roof poles(B). The roof poles
should appear as below.
E E
C
B A B
E C E
ASSEMBLY INSTRUCTIONS
Magellan Bryce Canyon(23-103) 19'x10'
STEP 5: Place the 2 steel main leg poles(C+D), color coded red and insert
them into the middle roof pole ends. Next, place the 4 steel leg poles(E),
color coded blue, by the side of the tent and attach one end of each of
these poles to the corresponding opening of the side plastic molds(F).
STEP 6: Take hold of the main leg poles(C+D) and lift them up to stretch the
tent materials. Note that you can adjust the height with plastic clamp pre-
attached in the main leg pole(D). The base of the main leg poles should be
near the middle stake loops at the base of the tent. Next, take one-side 2
corner leg poles(E) and lift them up so you can adjust the placement of the
corner poles until the tent stands firm. Repeat this step for the other
side of the tent.
STEP 7: Continue to stake the tent by using the tent stakes and the stake
loops at the base of the tent, making certain to pull the tent out even and
tight. The tent should appear as shown.
STEP 8: Unfold the rainfly and stretch out the corners. Once the front
of the rainfly has been located, place the rainfly over the tent. Attach
the rainfly's s-hooks to the steel triangle rings at the middle of the steel
leg frames and Wrap the Velcro tabs on the rainfly around the steel tent
leg poles.
STEP 9: Finally, finish by securing the fly with remaining stakes.
The tent should appear as shown.
NOTE: To take down the tent, follow the steps above in reverse order.
Be sure to leave doors and windows unzipped. Place stakes into stake
bag and poles into pole bag, which are provided.
The tent should be folded into equal parts toward the center of the tent
to distribute the bulk. Fold fly and lay on top of the tent. Start a small
tight roll, the width of your carry bag, with the pole bag placed at the
opposite the door. Roll tent toward door to allow air to escape. Once
rolled, secure with strings or rope. Slide tent and stake bag into carry
bag. Make sure the tent is clean and dry before storing. Store in a dry
area, off of concrete floor.