Canon imagePROGRAF PRO-310 Installing

在 Windows 以有線網路方式安裝及連接 imagePROGRAF PRO-310 打印機
以下步驟及畫面僅供參考，實際操作畫面可能因裝置型號、系統或軟件版本而有所不同。
The following steps and screens are for reference only, and the actual operation screens may vary depending on
the device model, system, or software version.
有線設定 Wired LAN Setup
確保在開始有線連接設定之前，印表機已開啟。
1.
如果電源開啟，電源指示燈將亮起。
Make sure printer is turned on before starting wired connection setup.
If the power is on, the ON lamp will be lit.
需要乙太網路電纜線(另行出售)。
2.
You will need an Ethernet cable (sold separately).
取下位於印表機後部左側連接埠的蓋。
3.
Remove the Cap from the port located on the left side at the back of the printer.
Installing imagePROGRAF PRO-310 on Windows via LAN connection
1